3D Layout of Interdigital Transducers for High Frequency Surface Acoustic Wave Devices
Open Access
- 6 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 123262-123271
Abstract
The development of mobile communication sets higher demands on high frequency surface acoustic wave (SAW) devices. The layout of interdigital transducers (IDT) in SAW devices is in plane and the traditional methods of improving frequency for SAW devices are the increase of acoustic velocity and the reduction of wavelength. However, these methods have a limit due to the limited acoustic velocity and the photolithography limit. This work proposes a new way for the development of high frequency SAW devices by redesigning the layout of IDT in three dimensions (3D). The set of IDTs is split into two layers, i.e. the ground electrodes on one layer and the signal electrodes on the other layer. This 3D layout of IDTs dramatically narrows the horizontal gap between two adjacent electrodes, which can significantly increase the frequency. The frequency and the electromechanical coupling factor ( $K^{2}$ ) of the four structures of SAW devices with the 3D layout of IDTs were studied by the finite element method (FEM). The results show that the frequency can be doubled under the same critical resolution of lithography due to the shortening of wavelength, and the 3D layout of IDTs is available for SAW devices based on piezoelectric thin film or piezoelectric single crystal. This work develops a new alternative to increase the working frequency of SAW devices.Keywords
Funding Information
- National Basic Research Program of China (2016YFB0402700)
This publication has 41 references indexed in Scilit:
- Performance Prediction and Sensitivity Analysis of SAW Gas SensorsIEEE Access, 2015
- Simulation of solidly mounted plate wave resonator with wide bandwidth using 0-th shear horizontal mode in LiNbO3plateJapanese Journal of Applied Physics, 2015
- Surface acoustic wave propagation characteristics of ScAlN/diamond structure with buried electrode2014
- Controlling the transmission of ultrahigh frequency bulk acoustic waves in silicon by 45° mirrorsUltrasonics, 2011
- Design, simulation, and visualization of R-SPUDT devices with transverse mode suppressionIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2010
- High-frequency sensor technologies for inertial force detection based on thin-film bulk acoustic wave resonators (FBAR)Microelectronic Engineering, 2009
- Rayleigh surface acoustic wave modes of interdigital transducer/(100) AlN/(111) diamondJournal of Applied Physics, 2008
- Characteristics of an AlN-based bulk acoustic wave resonator in the super high frequency rangeVacuum, 2008
- 5 GHz surface acoustic wave devices based on aluminum nitride/diamond layered structure realized using electron beam lithographyApplied Physics Letters, 2006
- Coupling Efficiency Estimates for Acoustic Surface Wave Excitation with Piezoelectric Film OverlaysJournal of Applied Physics, 1971