Effect of argon flow rate on the weld bead characteristics of TIG coating
Authors:
Open Access
- 1 April 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 804 (1) , 012016
Abstract
The research workinvestigatethe weld bead characteristics of WC-CoCr coatingfabricated by using tungsten inert gas welding process. Owing to the heat generated during the TIG coating, the extent of the temperature rise is adequate to cause the significant changes inthe melt dimensions of the coating. Toolmakers microscope has been used to capture the coating cross-section obtained at different values of argon flow rate. ImageJ software has been used to measure the porosity level in the coatings. The results shows that higher flow rate of argon gas increases the porosity and weld contamination in thecoating, because of the turbulencetakes place at higher flow rate.Keywords
This publication has 9 references indexed in Scilit:
- Abrasive wear behavior of WC-10Co-4Cr cladding deposited by TIG welding processInternational Journal of Refractory Metals and Hard Materials, 2020
- The effects of welding parameters on wear performance of clad layer with TiC ceramicIndustrial Lubrication and Tribology, 2012
- Sliding and Abrasive Wear Behavior of WC-CoCr Coatings with Different Carbide SizesJournal of Materials Engineering and Performance, 2012
- The effect of hydrogen shielding gas on microstructure and abrasive wear behavior in the surface modification process using the tungsten inert gas methodJournal of Coatings Technology and Research, 2010
- Dry sliding wear behavior of TIG welding clad WC composite coatingsApplied Surface Science, 2005
- Tungsten inert gas surface modification of SAE 4140 steelMaterials Science and Technology, 2002
- Tungsten-inert gas surface alloying of a low carbon steelSurface and Coatings Technology, 2002
- Intermetallic coatings produced by TIG surface meltingJournal of Materials Processing Technology, 2001
- Microstructure and hydroabrasive wear behaviour of high velocity oxy-fuel thermally sprayed WCCo(Cr) coatingsSurface and Coatings Technology, 1993