Substrate-decoupled silicon disk resonators having degenerate gyroscopic modes with Q in excess of 1-million
Authors:
- 1 June 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 156 (2159547X) , 15-18
Abstract
This paper details a center-supported solid disk resonator in <;100> single-crystalline-silicon (SCS) that uses a novel substrate decoupling feature to achieve ultra-low dissipation gyroscopic modes with small frequency split. The secondary bulk acoustic wave (BAW) elliptic modes (m = 3) of a 2mm diameter substrate-decoupled disk resonator exhibit quality factor (Q) of ~1.3 M with 40 ppm frequency split (as fabricated) at 2.745 MHz. Q-factor remained in excess of 1 million at pressure levels as high as 500 mTorr. The measured temperature behavior of the Q, which is mostly limited by thermoelastic damping (TED), is in very close agreement with FEM predictions.Keywords
This publication has 11 references indexed in Scilit:
- Multi-DOF inertial MEMS: From gaming to dead reckoning2011
- Energy dissipation in micromechanical resonators2011
- 5.4-MHz single-crystal silicon wine glass mode disk resonator with quality factor of 2 millionSensors and Actuators A: Physical, 2009
- High-Qbulk-mode SOI square resonators with straight-beam anchorsJournal of Micromechanics and Microengineering, 2008
- Squeeze-film damping in the free molecular regime: model validation and measurement on a MEMSJournal of Micromechanics and Microengineering, 2007
- Support loss in the radial bulk-mode vibrations of center-supported micromechanical disk resonatorsSensors and Actuators A: Physical, 2007
- MEMS technology for timing and frequency controlIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2007
- Capacitive Bulk Acoustic Wave Silicon Disk Gyroscopes2006
- Elastic PMLs for resonator anchor loss simulationInternational Journal for Numerical Methods in Engineering, 2005
- Energy dissipation in submicrometer thick single-crystal silicon cantileversJournal of Microelectromechanical Systems, 2002