Influence of Rim Seal Purge Flow on the Performance of an Endwall-Profiled Axial Turbine
Authors:
- 21 October 2010
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 133 (2) , 021011
Abstract
Nonaxisymmetric endwall profiling is a promising method to reduce secondary losses in axial turbines. However, in high-pressure turbines, a small amount of air is ejected at the hub rim seal to prevent the ingestion of hot gases into the cavity between the stator and the rotor disk. This rim seal purge flow has a strong influence on the development of the hub secondary flow structures. This paper presents time-resolved experimental and computational data for a one-and-1/2-stage high work axial turbine, showing the influence of purge flow on the performance of two different nonaxisymmetric endwalls and the axisymmetric baseline case. The experimental total-to-total efficiency assessment reveals that the nonaxisymmetric endwalls lose some of their benefit relative to the baseline case when purge is increased. The first endwall design loses 50% of the efficiency improvement seen with low suction, while the second endwall design exhibits a 34% deterioration. The time-resolved computations show that the rotor dominates the static pressure field at the rim seal exit when purge flow is present. Therefore, the purge flow establishes itself as jets emerging at the blade suction side corner. The jet strength is modulated by the first vane pressure field. The jets introduce circumferential vorticity as they enter the annulus. As the injected fluid is turned around the rotor leading edge, a streamwise vortex component is created. The dominating leakage vortex has the same sense of rotation as the rotor hub passage vortex. The first endwall design causes the strongest circumferential variation in the rim seal exit static pressure field. Therefore, the jets are stronger with this geometry and introduce more vorticity than the other two cases. As a consequence the experimental data at the rotor exit shows the greatest unsteadiness within the rotor hub passage with the first endwall design.Keywords
This publication has 26 references indexed in Scilit:
- Unsteady Flow Physics and Performance of a One-and-1∕2-Stage Unshrouded High Work TurbineJournal of Turbomachinery, 2006
- Effect of the Hub Endwall Cavity Flow on the Flow-Field of a Transonic High-Pressure TurbineJournal of Turbomachinery, 2004
- Mainstream Aerodynamic Effects Due to Wheelspace Coolant Injection in a High-Pressure Turbine Stage: Part I—Aerodynamic Measurements in the Stationary FrameJournal of Turbomachinery, 2001
- Mainstream Aerodynamic Effects Due to Wheelspace Coolant Injection in a High-Pressure Turbine Stage: Part II—Aerodynamic Measurements in the Rotational FrameJournal of Turbomachinery, 2001
- Time-resolved flow measurements with fast-response aerodynamic probes in turbomachinesMeasurement Science and Technology, 2000
- Nonaxisymmetric Turbine End Wall Design: Part II—Experimental ValidationJournal of Turbomachinery, 1999
- Performance of Radial Clearance Rim Seals in Upstream and Downstream Rotor–Stator WheelspacesJournal of Turbomachinery, 1992
- Rim Sealing of Rotor–Stator Wheelspaces in the Absence of External FlowJournal of Turbomachinery, 1992
- An Experimental Investigation of a Gas Turbine Disk Cooling SystemJournal of Engineering for Gas Turbines and Power, 1984
- Natural Transition of Boundary Layers—The Effects of Turbulence, Pressure Gradient, and Flow HistoryJournal of Mechanical Engineering Science, 1980