Investigation of Porosity Changes in Cast Ti6Al4V Rods After Hot Isostatic Pressing
Authors:
- 23 June 2015
- journal article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 24 (8) , 3137-3141
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- X-ray computed tomography of a titanium aerospace investment castingCase Studies in Nondestructive Testing and Evaluation, 2015
- XCT analysis of the influence of melt strategies on defect population in Ti–6Al–4V components manufactured by Selective Electron Beam MeltingMaterials Characterization, 2015
- Simple and fast porosity analysis of concrete using X-ray computed tomographyMaterials and Structures, 2014
- Effect of Micro-porosities on Fatigue Behavior in Aluminum Die Castings by 3D X-ray Tomography InspectionISIJ International, 2014
- Quantitative X-ray tomographyInternational Materials Reviews, 2014
- Pore annihilation in a single-crystal nickel-base superalloy during hot isostatic pressing: Experiment and modellingMaterials Science and Engineering: A, 2013
- Characterization of microshrinkage casting defects of Al–Si alloys by X-ray computed tomography and metallographyInternational Journal of Fatigue, 2012
- X-ray computed tomography vs. metallography for pore sizing and fatigue of cast Al-alloysProcedia Engineering, 2010
- Titanium investiment casting defects: A metallographic overviewJOM, 2006
- Fundamental aspects of hot isostatic pressing: An overviewMetallurgical and Materials Transactions A, 2000