Nano-particulate pressed powder tablets for LA-ICP-MS
Open Access
- 16 April 2014
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 29 (6) , 990-1000
Abstract
We developed an advanced method for producing undiluted nano-particulate pressed powder tablets without addition of any binder applying wet-milling protocols in aqueous suspension using a high power planetary ball mill and agate tools. The method was tested and optimized for the milling time, ball size, ball-to-powder ratio and water-to-powder ratio using pulverized diorite DR-N containing abundant zircon crystals that are especially difficult to break down by both milling and acid-digestion methods. The new method produces nano-particulate powders with typical grain size d50 < 1.5 μm allowing us to form pressed powder tablets with excellent cohesion and homogeneity suitable for laser ablation micro-analysis. The optimized milling protocol was applied to a selection of other natural rock CRMs (BHVO-2, JGb-1, UB-N, AC-E, GA) covering a wide range of rock types, and formed powder tablets were analyzed by LA-ICPMS. Precision was found to be in the same range of e.g., volcanic glasses, vitrified rock powders), and preferred values could be reproduced within uncertainty for most of the 38 trace and ultra-trace elements analyzed. Our new method accomplishes the preparation of refractory sample materials or materials containing refractory mineral phases (e.g., plutonic rocks and sediments, ultramafic rocks, oxides as in banded iron formation, ceramics) for subsequent analysis by LA-ICPMS. Even more importantly, this method opens up new prospects for the manufacturing (and possibly isotopic spiking) of homogenized reference materials from natural minerals that are urgently needed for true matrix-matched calibration and validation of LA-ICP-MS geochemical and isotope data.Keywords
This publication has 57 references indexed in Scilit:
- Effect of oxygen in sample carrier gas on laser-induced elemental fractionation in U–Th–Pb zircon dating by laser ablation ICP-MSJournal of Analytical Atomic Spectrometry, 2014
- Experimental and theoretical investigations about the vaporization of laser-produced aerosols and individual particles inside inductively-coupled plasmas — Implications for the extraction efficiency of ions prior to mass spectrometrySpectrochimica Acta Part B: Atomic Spectroscopy, 2012
- Evaluation of space charge effects in the second vacuum stage of a commercial inductively coupled plasma mass spectrometer by planar laser-induced fluorescence imagingSpectrochimica Acta Part B: Atomic Spectroscopy, 2012
- Inductively Coupled Plasma–Mass Spectrometry (ICP-MS) for Quantitative Analysis in Environmental and Life Sciences: A Review of Challenges, Solutions, and TrendsApplied Spectroscopy, 2012
- Review of the State-of-the-Art of Laser Ablation Inductively Coupled Plasma Mass SpectrometryApplied Spectroscopy, 2011
- Signal enhancement in laser ablation ICP-MS by addition of nitrogen in the central channel gasJournal of Analytical Atomic Spectrometry, 2008
- Sensitivity enhancement in laser ablation ICP-MS using small amounts of hydrogen in the carrier gasJournal of Analytical Atomic Spectrometry, 2007
- Elemental fractionation in laser ablation-inductively coupled plasma-mass spectrometry: evidence for mass load induced matrix effects in the ICP during ablation of a silicate glassJournal of Analytical Atomic Spectrometry, 2006
- Capabilities of a homogenized 266 nm Nd:YAG laser ablation system for LA-ICP-MSJournal of Analytical Atomic Spectrometry, 2001
- Characteristics and capabilities of an ICP-MS with a dynamic reaction cell for dry aerosols and laser ablationJournal of Analytical Atomic Spectrometry, 2000