Scaled FinFETs Connected by Using Both Wafer Sides for Routing via Buried Power Rails
- 28 September 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (12) , 7173-7179
Abstract
We report on scaled finFETs built with a novel routing scheme wherein devices are connected via buried power rails (BPRs) from both wafer sides, with tight variability and matching control. On the wafer’s frontside (FS), M1 lines (FSM1) are connected through V0 vias to M0A lines which are then linked to BPR lines by vias called VBPR while also contacting directly the device’s S/D-epi. As for gate wiring, to enable in this work its access from both wafer sides, gate is also connected to BPR via V0 landing on it and on a neighboring M0A line set only on field-oxide. A single-step metallization for M0A and VBPR is preceded by in situ preclean(s) optimized for improved BPR-VBPR contact interface and $\textit{R}_{\text{ext}}$ , as confirmed electrically and by physical analysis. After FS processing, wafer flipping, bonding, and extreme thinning, highly scaled, $\sim $ 323 nm deep nano-through-Si-vias (nTSVs) land on BPR, with tight overlay control and unchanged BPR resistance 26%–29% lower with improved tungsten (W)-fill, connecting them to the first backside (BS) metal level (BSM1). By moving the power delivery network to the BS (BSPDN), besides alleviating FS routing congestion, considerably smaller dynamic and static IR drop values are predicted from on-chip power heat maps generated for a low power 64-bit CPU at 2-nm design rules: 82% and 96% less worst-case values versus a reference configuration, respectively. P/NMOS show similar or even superior $\textit{I}_{\biosc{on}}$ – $\textit{I}_{\biosc{off}}$ after BS processing and extra anneal(s) added for $\textit{V}_{\textit{T}}$ recovery, mobility and bias temperature instability (BTI) improvement—up to 8%/15% higher $\textit{I}_{\biosc{on}}$ linked to anneal selection.Keywords
This publication has 14 references indexed in Scilit:
- From Design to System-Technology optimization for CMOS2021
- Buried Power Rail Integration with Si FinFETs for CMOS Scaling beyond the 5 nm Node2020
- Extreme Wafer Thinning and nano-TSV processing for 3D Heterogeneous Integration2020
- Buried Power Rails and Back-side Power Grids: Arm® CPU Power Delivery Network Design Beyond 5nm2019
- Direct Bonding of low Temperature Heterogeneous Dielectrics2019
- Extending the roadmap beyond 3nm through system scaling boosters: A case study on Buried Power Rail and Backside Power Delivery2019
- Voltage Ramp Stress for Bias Temperature Instability Testing of Metal-Gate/High- $k$ StacksIEEE Electron Device Letters, 2009
- Ubiquitous relaxation in BTI stressing—New evaluation and insights2008
- Fundamental understanding and optimization of PBTI in nFETs with SiO2/HfO2 gate stack2006
- Improved reliability characteristics of ultrathin high-k MOSFET with TiN gate by employing two step post deposition annealing process2005