Inorganic Layers on Polymeric Films – Influence of Defects and Morphology on Barrier Properties
Authors:
- 5 May 2003
- journal article
- research article
- Published by Wiley in Chemical Engineering & Technology
- Vol. 26 (5) , 605-614
Abstract
Flexible polymeric films are not only widely used in conventional packaging as substitute for glass and aluminum foil packaging but are also proposed as encapsulation for novel products, like flexible solar cells or organic light‐emitting devices. The two essential properties of the polymeric packaging are flexibility and good permeation barrier properties against gases and vapors. This article deals with vacuum web coating as a common way of increasing barrier properties of polymeric films and the problems related to this procedure. Defects caused by particles and surface imperfections are found to dominate the permeation rate for such coated polymeric films. Atomic force microscopy, electron and also optical microscopy was used for analysis of the coating layer. Three‐dimensional numerical simulations were performed for modeling of the influence of defect size, spacing and film thickness. Results of numerical modeling and of many practical experiments show that the permeability is almost independent of the substrate film thickness when a critical thickness is exceeded. In most cases the defects can be treated as independent of each other. The gas permeability of vacuum web‐coated polymeric films can be quantitatively predicted by a simple formula. For gases, like oxygen, it is shown that a statistic analysis of the defect sizes by optical microscopy is sufficient. For water vapor transmission, however, the structure of the coating layer itself has also to be taken into account.Keywords
This publication has 18 references indexed in Scilit:
- How cracks in SiOx-coated polyester films affect gas permeationThin Solid Films, 2001
- Reactive barrier filmsAIChE Journal, 2001
- The transport properties of CO2 and CH4 for chemically modified polysulfonesJournal of Applied Polymer Science, 2000
- PVD coating of plastic webs and sheets with high rates on large areasSurface and Coatings Technology, 2000
- Preparation of oxygen gas barrier poly(ethylene terephthalate) films by deposition of silicon oxide films plasma-polymerized from a mixture of tetramethoxysilane and oxygenJournal of Applied Polymer Science, 1999
- Application of Pervaporation and Vapor Permeation Processes to Separate Aqueous Ethanoi Solution through Chemically Modified Nylon 4 MembranesSeparation Science and Technology, 1998
- Overview on modern vacuum web coating technologySurface and Coatings Technology, 1996
- Estimating diffusion through flake-filled membranesJournal of Membrane Science, 1996
- Sorption and transport of CO2 and CH4 in chemically modified poly(phenylene oxide)Journal of Membrane Science, 1992
- Web metallizing with dense, directional and energetic Al-vapour jets—a challenge to conventional evaporatorsVacuum, 1991