Design considerations for direct RF sampling receiver in GNSS environment
- 1 March 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 9-13
Abstract
In this paper, the applicability of advanced direct RF sampling receiver architecture is studied in the GNSS environment. The architecture is based on sampling the signal directly at RF, which in the GNSS case is in the 1.5 GHz range. The high-frequencies in the signal to be sampled pose then very high demands for the accuracy and quality of the sampling process, and thus quantization and especially the timing jitter aspects must be considered in detail. Both system calculations as well as computer simulations are used to assess the essential requirements for the sampling process. In summary, the study shows that the quantization and jitter requirements are in principle feasible when the pre-sampling filtering is done properly.Keywords
This publication has 8 references indexed in Scilit:
- Jitter requirements of the sampling clock in software radio receiversIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2006
- Aperture Jitter Effects in Software Radio GNSS ReceiversJournal of Global Positioning Systems, 2004
- Practical RF System Design2003
- A fully integrated low-IF CMOS GPS radio with on-chip analog image rejectionIEEE Journal of Solid-State Circuits, 2002
- Signal processing challenges for applying software radio principles in future wireless terminals: an overviewInternational Journal of Communication Systems, 2002
- Analog-to-digital converter survey and analysisIEEE Journal on Selected Areas in Communications, 1999
- Design and implementation of a direct digitization GPS receiver front endIEEE Transactions on Microwave Theory and Techniques, 1996
- Jitter analysis of high-speed sampling systemsIEEE Journal of Solid-State Circuits, 1990