Hydrogenation of 1,5,9‐cyclododecatriene in fixed‐bed reactors: Down‐ vs. upflow modes
Authors:
- 1 January 2002
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 48 (1) , 110-125
Abstract
Performance of trickle‐bed and up‐flow reactors was studied experimentally and theoretically for an exothermic multistep hydrogenation of 1,5,9‐cyclododecatriene (CDT) in n‐decane as solvent over 0.5% Pd/alumina catalyst. Intrinsic kinetics was studied in a batch stirred slurry reactor using the powdered catalyst, and a Langmuir‐Hinshelwood‐type rate model is proposed. Using this rate equation, a trickle‐bed‐reactor model was developed that incorporates contributions of partial wetting and stagnant liquid holdup, in addition to the external and intraparticle mass transfer for the gas‐phase reactant (hydrogen). It was also modified to describe the behavior of the upflow reactor. Experimental data were obtained in both upflow (trickle‐bed) and down‐flow modes at different liquid velocities, pressures, and inlet feed concentrations at 373–413 K. Reactor performance of the two modes was compared in terms of global hydrogenation rate, CDT conversion, selectivity to cyclododecene and the maximum temperature rise observed in the catalyst bed. The conversions and global hydrogenation rate were significantly higher in a trickle‐bed reactor than in the upflow reactor. Similarly, a significant temperature rise in the catalyst bed was observed for the downflow operation compared to the upflow mode, which is explained from wetting characteristics of the catalyst bed. Model predictions for both reactors agreed well with experimental data.Keywords
This publication has 38 references indexed in Scilit:
- A trickle-bed reactor model for hydrogenation of 2,4 dinitrotoluene: experimental verificationChemical Engineering Science, 1998
- Modeling and comparison of acetophenone hydrogenation in trickle-bed and slurry airlift reactorsChemical Engineering Science, 1997
- High-Pressure Trickle-Bed Reactors: A ReviewIndustrial & Engineering Chemistry Research, 1997
- Catalyst bed dilution for improving catalyst wetting in laboratory trickle‐bed reactorsAIChE Journal, 1996
- Kinetic Modeling of the Hydrogenation of 1,5,9-Cyclododecatriene on Pd/Al2O3 Catalyst Including IsomerizationIndustrial & Engineering Chemistry Research, 1996
- Multiphase Catalytic Reactors in the Oil Industry: an IntroductionRevue de l'Institut Français du Pétrole, 1991
- Upflow versus downflow testing of hydrotreating catalystsApplied Catalysis, 1988
- Modeling of hydrogenation of glucose in a continuous slurry reactorIndustrial & Engineering Chemistry Process Design and Development, 1984
- Heat Transfer in Gas-Liquid-Solid Reactors1981
- Effectiveness factors for general reaction rate formsAIChE Journal, 1965