Influence of Air-Barrier and Curing Light Distance on Conversion and Micro-Hardness of Dental Polymeric Materials
Open Access
Abstract
This study aims to assess the conversion degree and hardness behavior of two new commercial dental restorative composites that have been submitted to light curing in different environments (air and glycerin, respectively) at various distances from the light source (1 to 5 mm) and to better understand the influence of the preparation conditions of the restorative materials. Through FT-IR spectrometry, the crosslinking degree of the commercial restorative materials have been investigated and different conversion values were obtained (from ~17% to ~90%) but more importantly, it was shown that the polymerization environment exhibits a significant influence on the crosslinking degree of the resin-based composites especially for obtaining degrees of higher polymerization. Additionally, the mechanical properties of the restorative materials were studied using the nanoindentation technique showing that the nano-hardness behavior is strongly influenced not only by the polymerization lamp position, but also by the chemical structure of the materials and polymerization conditions. Thus, the nanoindentation results showed that the highest nano-hardness values (~0.86 GPa) were obtained in the case of the flowable C3 composite that contains BisEMA and UDMA as a polymerizable organic matrix when crosslinked at 1 mm distance from the curing lamp using glycerin as an oxygen-inhibitor layer.Keywords
Funding Information
- “Carol Davila” University of Medicine and Pharmacy Bucharest (CNFIS-FDI-2022-0253)
- Romanian Ministry of Education
- European Regional Development Fund (P_36_611)
- PubArt Programme from University Politehnica of Bucharest
This publication has 57 references indexed in Scilit:
- Degree of conversion of nano-hybrid resin-based composites with novel and conventional matrix formulationClinical Oral Investigations, 2012
- An evalution of compressive strength of newer nanocomposite: An in vitro studyJournal of Conservative Dentistry, 2011
- Recent Advances and Developments in Composite Dental Restorative MaterialsJournal of Dental Research, 2010
- Effects of monomer ratios and highly radiopaque fillers on degree of conversion and shrinkage-strain of dental resin compositesDental Materials, 2009
- Influence of BisGMA, TEGDMA, and BisEMA contents on viscosity, conversion, and flexural strength of experimental resins and compositesEuropean Journal of Oral Sciences, 2009
- Antibacterial agents in composite restorations for the prevention of dental caries2009
- Influence of Light-polymerization Modes on the Degree of Conversion and Mechanical Properties of Resin Composites: A Comparative Analysis Between a Hybrid and a Nanofilled CompositeOperative Dentistry, 2008
- Influence of the distance of the curing light source and composite shade on hardness of two compositesJournal of Applied Oral Science, 2007
- Microhardness of composite resins at different depths varying the post-irradiation timeJournal of Applied Oral Science, 2007
- Factors affecting the quantity of remaining double bonds in restorative resin polymersEuropean Journal of Oral Sciences, 1982