Comparison of Peak Power Tracking Based Electric Power System Architectures for CubeSats
- 29 January 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 57 (3) , 2758-2768
Abstract
CubeSats have been widely used for space research due to lower cost and faster development. The electric power system (EPS) is one of the key subsystems of CubeSat which powers all the other subsystems. One of the important steps in the EPS design is the selection of EPS architecture which should be done considering overall efficiency, battery size, reliability, and simplicity of control. In the literature, a general comparison between different architectures is performed without considering the mission parameters, power generation profile, and load profile based on the operational modes. Thus, the best possible EPS architecture may not be selected in the design phase. Therefore, the main objective of this article is to develop a systematic methodology to compare various peak power tracking EPS architectures of CubeSat in terms of orbital efficiency for all possible modes of operation, component count, reliability, and battery size to meet the required number of cycles of charge/discharge for the given mission duration. The proposed methodology has been demonstrated using the real data and scenarios of MYSAT-1, which is a 1U CubeSat developed and launched by Khalifa University. The results demonstrate that EPS architecture with series-connected maximum power tracking converters for solar panels and unregulated dc-bus has the highest efficiency for all operating modes, lower component count, higher reliability, and minimum battery capacity or longer lifetime for the same battery specifications.Keywords
Funding Information
- Masdar Institute of Science and Technology
- Khalifa University of Science, Technology and Research
- Massachusetts Institute of Technology (02/MI/MIT/CP/11/07633/GEN/G/00)
This publication has 39 references indexed in Scilit:
- Design of Electrical Power Subsystem for IITMSAT2015
- Improving the efficiency of 3U CubeSat EPS by selecting operating conditions for power converters2015
- Design and optimization of the on board DC/DC converters of Swayam satellite2014
- Student research highlight smart panel bodies for modular small satellitesIEEE Aerospace and Electronic Systems Magazine, 2014
- Evaluation of $\hbox{LiFePO}_{4}$ Batteries for Electric Vehicle ApplicationsIEEE Transactions on Industry Applications, 2014
- Characterization of Lithium-Polymer batteries for CubeSat applicationsActa Astronautica, 2011
- Design of Tokyo Tech nano-satellite Cute-1.7+APD II and its operationActa Astronautica, 2010
- Effect of operation conditions on simulated low-earth orbit cycle-life testing of commercial lithium-ion polymer cellsJournal of Power Sources, 2005
- Power subsystem design for the Montana EaRth Orbiting Pico-Explorer (MEROPE) CubeSat-class satellite2003
- Design and analysis of a regulated peak-power tracking systemIEEE Transactions on Aerospace and Electronic Systems, 1999