Field‐induced uniaxial magnetic anisotropy is observed in vacuum evaporated thin Fe–Co films over the entire composition range. Using an inductively heated slug, a consistently reproducible relation between slug composition and film composition was found with the maximum difference occurring near 30% Co where the film turned out to be 47% Co. A uniaxial anisotropy, with the easy axis parallel to a field during evaporation, was observed using a torque magnetometer. The observed value of Ku as a function of composition, for films made on substrates at 300°C, increased smoothly from 2×103 ergs/cm3 for Fe to a maximum of 35×103 ergs/cm3 for FeCo and then decreased to 10×103 ergs/cm3 for Co. No indication of a reduction of the anisotropy constant could be observed at the Fe2Co, FeCo or FeCo3 composition even after post‐evaporative anneals up to 70 h at 300°C. The observed value of Ku for films made at room temperature was similar. For selected compositions, Ku was observed to be less for films evaporated onto hotter substrates. The FeCo composition changed least with a 10% reduction from −200° to +525°C. It is concluded that, in contrast to the situation in Fe‐Ni alloys, the contribution from pair orientation to Ku must be very small. The coercive force of all films was in the 10 to 60 Oe range with considerable spread observed; the films were generally inverted. The rotational hysteresis integral scattered from 0.5 to 2.2 with no substantial trend observed.