Effect of glycerol concentrations on the mechanical properties of additive manufactured porous calcium polyphosphate structures for bone substitute applications
- 24 January 2016
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 105 (4) , 828-835
Abstract
This article addresses the effects of glycerol (GLY) concentrations on the mechanical properties of calcium polyphosphate (CPP) bone substitute structures manufactured using binder jetting additive manufacturing. To achieve this goal, nine types of water-based binder solutions were prepared with 10, 12.5, and 15 wt % GLY liquid-binding agent, mixed, respectively, with 0, 0.75, and 1.5 wt % ethylene glycol diacetate (EGD) flow enhancer. The print quality of each of the solutions was established quantitatively using an image processing algorithm. The print quality analysis narrowed down the solutions to three batches containing 1.5 wt % EGD and variable amount of GLY. These solutions were used to manufacture porous CPP bone substitute samples, which were characterized physically to determine shrinkage, porosity, microstructure, and compression strength. The 12.5 wt % GLY, 1.5 wt % EGD solution resulted in the highest mechanical strength after sintering (34.6 ± 5.8 MPa), illustrating similar mechanical properties when compared to previous studies (33.9 ± 6.3 MPa) of additively manufactured CPP bone substitutes using a commercially available binder. © 2016 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 105B: 828–835, 2017.Keywords
Funding Information
- The Natural Sciences and Engineering Research Council (NSERC) of Canada grant (# RGPIN312074 37063)
This publication has 29 references indexed in Scilit:
- Characterizations of additive manufactured porous titanium implantsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2012
- Mechanical characteristics of solid-freeform-fabricated porous calcium polyphosphate structures with oriented stacked layersActa Biomaterialia, 2011
- A review of process development steps for new material systems in three dimensional printing (3DP)Journal of Manufacturing Processes, 2008
- 3D printing of hydroxyapatite: Effect of binder concentration in pre-coated particle on part strengthMaterials Science and Engineering: C, 2007
- Improvement in mechanical properties of three‐dimensional printing parts made from natural polymers reinforced by acrylate resin for biomedical applications: a double infiltration approachPolymer International, 2005
- Porosity of 3D biomaterial scaffolds and osteogenesisBiomaterials, 2005
- Rapid prototyping in tissue engineering: challenges and potentialTrends in Biotechnology, 2004
- Improved surface finish in 3D printing using bimodal powder distributionRapid Prototyping Journal, 2003
- Scaffold development using 3D printing with a starch-based polymerMaterials Science and Engineering: C, 2002
- Ink‐Jet Printing of Binders for Ceramic ComponentsJournal of the American Ceramic Society, 2002