Analysis, Design and Experimental Results of Wide Range ZVS Active-Clamped L-L Type Current-Fed DC/DC Converter for Fuel Cells to Utility Interface
Authors:
- 21 April 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 59 (1) , 473-485
Abstract
A wide range zero-voltage switching (ZVS) active-clamped L-L type current-fed isolated dc-dc converter is proposed for fuel cells to utility interface application. The proposed converter maintains ZVS of all switches from full load down to very light load condition for wide input voltage variation. Detailed operation, analysis, design, simulation and experimental results for the proposed converter are presented. The auxiliary active clamping circuit absorbs the turn-off voltage spike and also assists in achieving ZVS of main switches. The ZVS of auxiliary switches and main switches is achieved by the energy stored in the boost inductors and series inductor (aided by parallel inductor), respectively. Rectifier diodes operate with zero-current switching. An experimental converter rated at 200 W has been designed, built and tested in the laboratory to verify the analysis, design and performance of the proposed converter for wide variations in input voltage and load.Keywords
This publication has 34 references indexed in Scilit:
- Small signal analysis and closed loop control design of L-L type active-clamped ZVS current-fed isolated DC-DC converter2009
- A Comparison of Soft-Switched DC-DC Converters for Fuel Cell to Utility Interface Application2007
- An Analysis of the ZVS Two-Inductor Boost Converter under Variable Frequency OperationIEEE Transactions on Power Electronics, 2007
- A 10-kW SOFC low-Voltage battery hybrid power conditioning system for residential useIEEE Transactions on Energy Conversion, 2006
- A New DC-DC Converter for Fuel Cell Powered Distributed Residential Power Generation Systems2006
- A New Active Clamping Zero-Voltage Switching PWM Current-Fed Half-Bridge ConverterIEEE Transactions on Power Electronics, 2005
- An active-clamp push-pull converter for battery sourcing applications2005
- Power electronics as efficient interface in dispersed power generation systemsIEEE Transactions on Power Electronics, 2004
- A soft-switched, full-bridge boost converter employing an active-clamp circuit2002
- Switched snubber for high frequency switching2002