Maximum endurance time modeling for push and pull tasks considering gender and handle height
Authors:
- 5 September 2020
- journal article
- research article
- Published by Wiley in Human Factors and Ergonomics in Manufacturing & Service Industries
- Vol. 31 (1) , 3-12
Abstract
The strengths of both push and pull using both hands at handle heights of 75, 90, and 135 cm were measured for 11 female and 8 male participants. In addition, simulated push and pull tasks were performed on one of the three heights as in the strength measurements. In these tasks, the participants either pushed or pulled a swing suspended with one of the two loads (32.5 and 42.5 kg) until they could no longer do so. Then, the strength of push or pull was measured again. The participants also reported bodily discomfort on their body parts on a CR‐10 rating scale. It was found that hands and leading leg had the highest CR‐10 scores among the body parts and were the bottleneck body parts for the push and pull tasks, respectively. Models of maximum endurance time incorporating gender and handle height, in addition to force ratio, were developed. These models may be adopted in predicting the endurance time in job design concerning work/rest arrangement.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST 106‐2221‐E‐216‐008‐MY3)
This publication has 49 references indexed in Scilit:
- Muscular fatigue and maximum endurance time assessment for male and female industrial workersInternational Journal of Industrial Ergonomics, 2014
- Fatigue and recovery from dynamic contractions in men and women differ for arm and leg musclesMuscle & Nerve, 2013
- A three-compartment muscle fatigue model accurately predicts joint-specific maximum endurance times for sustained isometric tasksJournal of Biomechanics, 2012
- Endurance time is joint-specific: A modelling and meta-analysis investigationErgonomics, 2010
- Muscle fatigue: what, why and how it influences muscle functionThe Journal of Physiology, 2008
- Initial force and postural adaptations when pushing and pulling on floor surfaces with good and reduced resistance to slippingErgonomics, 2006
- Decrease of force capabilities as an index of upper limb fatigueErgonomics, 2005
- The effect of handle height and cart load on the initial hand forces in cart pushing and pullingErgonomics, 1999
- The effects of task duration on psychophysically-determined maximum acceptable weights and forcesErgonomics, 1990
- A study stressing the need for a static postural force model for work analysisErgonomics, 1986