Cold Forming Hybrid Aluminium–Carbon Fibre-Reinforced Polymer Sheets Joined by Mechanical Interlocking
Open Access
- 24 April 2025
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 9 (5) , 204
Abstract
Forming hybrid structures into complex shapes is key to address lightweighting of automotive parts. Recently, an innovative joining technique between aluminium and Carbon Fibre-Reinforced Polymer (CFRP) based on mechanical interlocking through sheet punching has been developed. However, scaling up the solution requires the assessment of challenges, such as multi-material forming and joint integrity, after forming operations. Therefore, this work proves the feasibility of forming aluminium–CFRP prepreg panels into complex omega-shaped profiles following a conventional cold-stamping process. Forming without defects was possible even in specimens featuring mechanical joints generated through punching. The effect of the CFRP position (in the inner or the outer side of the formed profile), the number of mechanical joints, the addition of a Glass Fibre-Reinforced Polymer (GFRP) intermediate layer to prevent galvanic corrosion and adequate lubrication on necking, cracking, springback behaviour and the final geometry after curing were studied. Compression tests were performed to assess the mechanical response of the hybrid profile, and the results showed that the addition of CFRP in the aluminium omega profile changed the buckling behaviour from global bending to axial folding, increasing the maximum compression load. Additionally, the presence of mechanical interlocking joints further improved the mechanical performance and led to a more controlled failure due to buckling localization in the geometric discontinuity.Keywords
Funding Information
- Catalan Government through the funding grant ACCIÓ-Eurecat (Project Flagship-Intelligent)
This publication has 28 references indexed in Scilit:
- A punching process to join metal sheets and fibre reinforced polymer composites by mechanical interlockingComposites Part A: Applied Science and Manufacturing, 2023
- Galling phenomena in metal formingFriction, 2020
- One‐Step Process for Press Hardened Steel–Carbon Fiber Reinforced Thermoset Polymer Hybrid PartsSteel Research International, 2020
- Introduction to CFRP-metal hybrids for lightweight structuresProduction Engineering, 2018
- The Role of Adhesive Forces and Mechanical Interaction on Material Transfer in Hot Forming of AluminiumTribology Letters, 2015
- The development and scalability of a high strength, damage tolerant, hybrid joining scheme for composite–metal structuresComposites Part A: Applied Science and Manufacturing, 2014
- Damage monitoring and analysis of composite laminates with an open hole and adhesively bonded repairs using digital image correlationComposites Part B: Engineering, 2013
- Experimental investigation of a novel hybrid metal–composite joining technologyComposites Part A: Applied Science and Manufacturing, 2010
- Mechanics of mechanically fastened joints in polymer–matrix composite structures – A reviewComposites Science and Technology, 2009
- Handbook of Metal FormingJournal of Applied Metalworking, 1986