Impact of Isothermal Aging on the Long-Term Reliability of Fine-Pitch Ball Grid Array Packages With Different Sn-Ag-Cu Solder Joints
Authors:
- 30 May 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 2 (8) , 1317-1328
Abstract
A direct and deleterious effect on packaging reliability has been observed during elevated temperature isothermal aging for fine-pitch ball grid array (BGA) packages with Sn-1.0Ag-0.5Cu (SAC105), Sn-3.0Ag-0.5Cu (SAC305), and Sn-37Pb solder ball interconnects. Package sizes ranging from 19 mm with 0.8-mm-pitch BGAs to 5 mm with 0.4-mm-pitch μ BGAs with three different board finishes (ImSn, ImAg, and SnPb) were evaluated. The aging temperatures were 25°C, 55°C, 85°C, and 125°C, applied for a period of 6 mo. Subsequently, the specimens were thermally cycled from -40°C to 125°C with 15-min dwell times at the high temperature. Weibull analysis of failures versus cycle number show a ~ 50% reduction in package lifetimes when aged at 125°C compared to the same at room temperature, with less dramatic but measurable reductions in lifetime at 85°C and even 55°C. In contrast, the reliability performance of Sn-37Pb is much more stable over time and temperature. The degradation was observed for both SAC alloys on all tested package sizes and board finishes. For the 19-mm SAC105 case, for example, there was a 53% (32%) reduction of characteristic lifetime at 125°C (85°C) compared to room temperature aging. The trends were in the expected directions; namely, the reliability was reduced when using higher aging temperatures, smaller solder balls, and SAC105. The dominant failure mode can be associated with the growth of Cu6Sn5 intermetallic compounds during the aging, particularly on the pad side.Keywords
This publication has 15 references indexed in Scilit:
- Isothermal Aging Effects on the Mechanical Shock Performance of Lead-Free Solder JointsIEEE Transactions on Components, Packaging and Manufacturing Technology, 2011
- Impact of Isothermal Aging on Long-Term Reliability of Fine-Pitch Ball Grid Array Packages with Sn-Ag-Cu Solder Interconnects: Surface Finish EffectsJournal of Electronic Materials, 2010
- Assembly Process Development for Fine Pitch Flip Chip Silicon-to-Silicon 3D Wafer Level Integration with No Flow UnderfillJournal of Microelectronics and Electronic Packaging, 2010
- A review of mechanical properties of lead-free solders for electronic packagingJournal of Materials Science, 2009
- Systematic Study on Thermo-Mechanical Durability of Pb-Free Assemblies: Experiments and FE AnalysisJournal of Electronic Packaging, 2005
- Aging effects on fracture behavior of 63Sn37Pb eutectic solder during tensile tests under the SEMMaterials Science and Engineering: A, 2004
- Low cycle fatigue models for lead-free soldersThin Solid Films, 2004
- Thermal cycling aging effects on Sn–Ag–Cu solder joint microstructure, IMC and strengthThin Solid Films, 2004
- Experimental investigation on the degradation of BGA solder ball shear strength due to room temperature aging2002
- Effects of Room Temperature Storage Time on the Shear Strength of PBGA Solder Balls2002