Thermal Design of a Spray-Based Heat Sink Integrated With a Compact Vapor Compression Cooling System for Removal of High Heat Fluxes
- 17 December 2014
- journal article
- conference paper
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 36 (14-15) , 1203-1217
Abstract
This paper describes the thermal design of a compact vapor compression refrigeration system for high heat flux removal. The system operates with R-134a as the working fluid and consists of a miniature compressor, a compact condenser, and a spray-based heat sink device that combines the expansion device (an array of micro-orifices) and the evaporator into a single unit. The SPHINX (Spray Heat Sink Integrated with the Expansion Device) unit has been designed based on a phenomenological model for the critical two-phase flow in the micro-orifices and phase-change heat transfer resulting from the spray atomization/jet impingement on the heated surface. The SPHINX model was solved together with mathematical models for the other system components (compressor and condenser) in order to obtain the heater surface temperature behavior as a function of the system variables. A parametric study was performed to evaluate the effect of several design variables on the system performance. Correlations available in the literature for spray cooling and two-phase jet impingement heat transfer were analyzed and critically compared. The results indicate that a cooling unit with two compressors in parallel is capable of removing thermal loads of up to 560 W (140 W/cm2) while maintaining the heater surface temperature below 85°C.Keywords
This publication has 40 references indexed in Scilit:
- Analysis of a platform for thermal management studies of microelectronics cooling methodsApplied Thermal Engineering, 2013
- Mini Vapor Cycle System for high density electronic cooling applicationsInternational Journal of Refrigeration, 2013
- Spray cooling of plain and copper-foam enhanced surfacesExperimental Thermal and Fluid Science, 2012
- A State-of-the-Art Review of Compact Vapor Compression Refrigeration Systems and Their ApplicationsHeat Transfer Engineering, 2012
- A Review of High-Heat-Flux Heat Removal TechnologiesJournal of Heat Transfer, 2011
- An experimental study of two-phase multiple jet cooling on finned surfaces using a dielectric fluidApplied Thermal Engineering, 2011
- A Review of Cooling in MicrochannelsHeat Transfer Engineering, 2011
- A STUDY OF SPRAY-IMPINGEMENT COOLING ON SMOOTH AND PIN-FINNED SURFACES USING FC-72Journal of Enhanced Heat Transfer, 2011
- Spray cooling characteristics of water and R-134a. Part I: nucleate boilingInternational Journal of Heat and Mass Transfer, 2004
- Correlation of sauter mean diameter and critical heat flux for spray cooling of small surfacesInternational Journal of Heat and Mass Transfer, 1995