Measurements of turbulent flow development in tubes and annuli with square or rounded entrances
Authors:
- 1 November 1963
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 9 (6) , 766-770
Abstract
Entrance‐region studies, based on static‐pressure measurements, were carried out with water flowing in annuli and a circular tube fitted with interchangeable square or rounded entrance sections. The tests covered the Reynolds number range from 16,000 to 70,000. For the annuli, the length of duct required to approach to within 5% of the fully developed pressure gradient was about 20 to 25 hydraulic diameters. This is in general accord with entrance length results for circular tubes and parallel‐plate channels but differs from prior results for the annulus which had indicated entrance lengths larger by a factor of ten. The results for the sharp entrance showed a definite effect of separation and were characterized by high loss coefficients. For the rounded entrance, the initial part of the flow development was laminar; the entrance‐region pressure drop did not substantially exceed (and in one case was less than) the corresponding fully developed pressure drop. Also for the rounded entrance, flow stability was improved and a monotonically decreasing pressure gradient obtained when a turbulent boundary layer was induced by means of a trip. Fully developed friction factors were calculated and compared with theory.Keywords
This publication has 4 references indexed in Scilit:
- Experimental Investigation of Turbulent Heat Transfer in the Entrance Region of a Circular ConduitJournal of Mechanical Engineering Science, 1962
- An experimental study of liquid‐phase turbulent diffusion: Part I. Fluid mechanical dataAIChE Journal, 1962
- Turbulent newtonian flow in annuliAIChE Journal, 1961
- Fluid Mechanics Studies—Isothermal Skin Friction in Flow through Annular SectionsIndustrial & Engineering Chemistry, 1955