Influence of Leading-Edge Geometry on Profile Losses in Turbines at Off-Design Incidence: Experimental Results and an Improved Correlation
Authors:
- 1 April 1997
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 119 (2) , 193-200
Abstract
The most recent correlations for turbine profile losses at off-design incidence include the leading-edge diameter as the only aspect of the leading-edge geometry that influences the losses. Cascade measurements are presented for two turbine blades that differ primarily in their leading-edge geometries. The incidence was varied over a range of ±20 deg and the results show significant discrepancies between the observed profile losses and those predicted by the available correlations. Using data from the present experiments, as well as cases from the literature for which sufficient geometric data are given, a revised correlation has been developed. The new correlation is a function of both the leading-edge diameter and the wedge angle, and it is significantly more successful than the existing correlations. It is argued that the off-design loss behavior of the blade is influenced by the magnitude of the discontinuity in curvature at the points where the leading-edge circle meets the rest of the blade profile. The wedge angle appears to be an approximate and convenient measure of the discontinuity in curvature at these blend points.Keywords
This publication has 16 references indexed in Scilit:
- The 1993 IGTI Scholar Lecture: Loss Mechanisms in TurbomachinesJournal of Turbomachinery, 1993
- Incidence Angle and Pitch–Chord Effects on Secondary Flows Downstream of a Turbine CascadeJournal of Turbomachinery, 1993
- The 1991 IGTI Scholar Lecture: The Role of Laminar-Turbulent Transition in Gas Turbine EnginesJournal of Turbomachinery, 1991
- An Improved Incidence Losses Prediction Method for Turbine AirfoilsJournal of Turbomachinery, 1990
- The Off-Design Performance of a Low-Pressure Turbine CascadeJournal of Turbomachinery, 1987
- Three-Dimensional Flow in a Low-Pressure Turbine Cascade at Its Design ConditionJournal of Turbomachinery, 1987
- Boundary-Layer Transition and Separation Near the Leading Edge of a High-Speed Turbine BladeJournal of Engineering for Gas Turbines and Power, 1985
- A Mean Line Prediction Method for Axial Flow Turbine EfficiencyJournal of Engineering for Power, 1982
- Improvements to the Ainley-Mathieson Method of Turbine Performance PredictionJournal of Engineering for Power, 1970
- Performance Estimation of Axial Flow TurbinesProceedings of the Institution of Mechanical Engineers, 1970