Transient Measurement Techniques in EHV Systems
Authors:
- 1 May 1978
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Apparatus and Systems
- Vol. PAS-97 (3) , 893-902
Abstract
Two different measuring techniques have been developed in order to reduce the measurement errors observed during recording of transients in EHV systems, caused by interference due to ground potential differences. The first one is based on the application of an opto-electronic link between the HV measuring apparatus and the remotely located multi- channel recorder. The second, more conventional technique utilizes a large copper band llaced in parallel with the measuring cable shield. An optimum geometry for the band and the cable was determined from a model study. Results of application of these two measuring techniques in EHV system tests are presented.Keywords
This publication has 6 references indexed in Scilit:
- Experience with the AEP 765-kV System Dumont -- Marysville -- Kammer Field TestsIEEE Transactions on Power Apparatus and Systems, 1978
- Behavior of the hydro-quebec 735-kV system under transient short-circuit conditions and its digital computer simulationIEEE Transactions on Power Apparatus and Systems, 1975
- Instrumentation Techniques in High Voltage Substations - Part I Measuring, Triggering and Interference ReductionIEEE Transactions on Power Apparatus and Systems, 1973
- Coupling between Lines at High FrequenciesIEEE Transactions on Electromagnetic Compatibility, 1967
- Coupling between Open and Shielded Wire Lines over a Ground PlaneIEEE Transactions on Electromagnetic Compatibility, 1967
- Methods for Reducing Induced Voltages in Secondary CircuitsIEEE Transactions on Power Apparatus and Systems, 1967