Ground effect results from the interference between sound traveling directly from a point source to a receiver and that reflected coherently from the ground. The frequencies associated with first and subsequent order destructive interference in excess attenuation spectra are determined by the source‐receiver geometry and the ground impedance. Typically if the ground is hard and smooth, then at grazing incidence the first destructive interference occurs at too high a frequency to be useful in noise control. However, the effective impedance of a rough, hard surface is finite, and destructive interference can occur at much lower frequencies over a hard, rough surface than if the surface is smooth. If the roughness is spaced periodically, then the phenomenon of diffraction assisted ground effect occurs. Instead of the single destructive minimum observed with randomly spaced roughness elements, a cluster of two or three destructive interference peaks are observed. This phenomenon has been explored through laboratory experiments using semi‐cylindrical, rectangular, and wedge‐shaped strips placed on a glass sheet. Use of multiple scatteringtheory for semi‐cylindrical roughness on a hard surface shows that the diffraction assisted effect depends on the number of roughness elements and their spacing. The extent to which the phenomenon could be exploited for noise control is discussed. [Work supported by European Community FP7 project no. 234306.]