Surfactant Design for the 1,1,1,2-Tetrafluoroethane−Water Interface: ab initioCalculations andin situHigh-Pressure Tensiometry
Authors:
- 14 September 2006
- journal article
- research article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 22 (21) , 8675-8683
Abstract
In situ high-pressure tensiometry and ab initio calculations were used to rationally design surfactants for the 1,1,1,2-tetrafluoroethane−water (HFA134a|W) interface. Nonbonded pair interaction (binding) energies (Eb) of the complexes between HFA134a and candidate surfactant tails were used to quantify the HFA-philicity of selected moieties. The interaction between HFA134a and an ether-based tail was shown to be predominantly electrostatic in nature and much more favorable than that between HFA134a and a methyl-based fragment. The interfacial activity of (i) amphiphiles typically found in FDA-approved pressurized metered-dose inhaler (pMDI) formulations, (ii) a series of nonionic surfactants with methylene-based tails, and (iii) a series of nonionic surfactants with ether-based tails was investigated at the HFA134a|W interface using in situ tensiometry. This is the first time that the tension of the surfactant-modified HFA134a|W interface has been reported in the literature. The ether-based surfactants were shown to be very interfacially active, with tension decreasing by as much as 27 mN·m-1. However, the methyl-based surfactants, including those from FDA-approved formulations, did not exhibit high activity at the HFA134a|W interface. These results are in direct agreement with the Eb calculations. Significant differences in interfacial activity are noted for surfactants at the 2H,3H-perfluoropentane (HPFP)|water and HFA134a|W interfaces. Care should be taken, therefore, when results from the mimicking solvent (HPFP) are extrapolated to HFA134a-based systems. The results shown here are of relevance in the selection of surfactants capable of forming and stabilizing reverse aqueous aggregates in HFA-based pMDIs, which are promising formulations for the systemic delivery of biomolecules to and through the lungs.Keywords
This publication has 35 references indexed in Scilit:
- Surfactant solubility and aggregate orientation in hydrofluoroalkanesInternational Journal of Pharmaceutics, 2005
- Synthesis and Solubility of Linear Poly(tetrafluoroethylene-co-vinyl acetate) in Dense CO2: Experimental and Molecular Modeling ResultsMacromolecules, 2004
- Effect of Grafted Lewis Base Groups on the Phase Behavior of Model Poly(dimethyl siloxanes) in CO2Industrial & Engineering Chemistry Research, 2003
- Exploring CO2-Philicity: Effects of Stepwise FluorinationThe Journal of Physical Chemistry B, 2003
- An Investigation of the Solubility of Various Compounds in the Hydrofluoroalkane Propellants and Possible Model Liquid PropellantsJournal of Aerosol Medicine, 2000
- Surfactant Dissolution and Water Solubilization in Chlorine-Free Liquified Gas PropellantsDrug Development and Industrial Pharmacy, 1998
- Molecular Modeling Approach for Contrasting the Interaction of Ethane and Hexafluoroethane with Carbon DioxideThe Journal of Physical Chemistry, 1996
- Comparison of atomic charges derived via different proceduresJournal of Computational Chemistry, 1993
- Diffusion coefficient in aqueous polymer solutionsJournal of Chemical & Engineering Data, 1991
- Thermodynamics of transfer of hydrogen halides (hydrogen chloride, hydrogen bromide) in glycerol-dimethylformamide mixtures from electromotive force measurementsJournal of Chemical & Engineering Data, 1990