Design of a Robotic Hand Gripper for Pick-and-Place Operations
Open Access
- 19 October 2026
- conference paper
- Published by MDPI AG in Engineering Proceedings
- Vol. 145 (1) , 22
Abstract
Robotic end-effectors play an important role in automated pick-and-place operations, particularly where lightweight components with different geometries must be handled reliably. This study presents the design, fabrication, integration, and comparative experimental evaluation of three lightweight robotic gripper architectures for a Dobot CR5 collaborative robot using fused deposition modeling (FDM). The investigated architectures comprise a parallel dual-finger gripper, a lightweight micro-servo linkage gripper, and a concentric three-finger gripper. An embedded sensor-assisted system incorporating ultrasonic proximity sensing and force-sensitive resistor (FSR) feedback was implemented using threshold-based control logic. The three architectures were evaluated under identical operating conditions using spherical polypropylene and cylindrical polyethylene workpieces over 1000 consecutive pick-and-place cycles per configuration. Grasp success, dropped-object events, structural integrity, cycle performance, positioning variation, maximum dynamic load, and electrical energy consumption were considered as performance metrics. Within the investigated test conditions, the concentric three-finger architecture achieved the highest grasp success rate of 98.4%, corresponding to 984 successful cycles and 16 dropped-object events, with no observable structural failure. The results indicate that the symmetric three-contact architecture provided improved grasp stability and structural behavior relative to the two alternative configurations for the tested polymer workpieces. The study demonstrates the value of controlled architecture-to-architecture evaluation in the development of additively manufactured robotic end-effectors while identifying broader object validation, long-term durability testing, calibrated force sensing, and continuous force regulation as areas for future investigation.Keywords
This publication has 19 references indexed in Scilit:
- A novel design and testing of force-sensorised robotic fingers for stable grasping of high value cropsMeasurement, 2026
- A geometric inverse kinematics solution for the dobot CR5Journal of Physics: Conference Series, 2026
- Design of a one-shot FDM-printed adaptive robotic gripper with rigid–flexible hybrid fingersMechatronics, 2026
- Design Optimization of a Variable Stiffness Robotic Gripper with Passive Restoration Fabricated by Multimaterial 3D PrintingAdvanced Robotics Research, 2025
- Soft robotic grippers: A review on technologies, materials, and applicationsSensors and Actuators A: Physical, 2024
- Design of robot grippers for binder jet products handlingScientific Reports, 2024
- A novel rigid-soft gripper for safe and reliable object handlingJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2024
- Design and manufacturing process of pneumatic soft gripper for additive manufacturingSensors and Actuators A: Physical, 2024
- Application, Development and Future Opportunities of Collaborative Robots (Cobots) in Manufacturing: A Literature ReviewInternational Journal of Human–Computer Interaction, 2022
- Actuation Technologies for Soft Robot Grippers and Manipulators: A ReviewCurrent Robotics Reports, 2021