Comparison of Euler-Euler and Euler-Lagrange Approaches for Simulating Gas-Solid Flows in a Multiple-Spouted Bed
Authors:
- Meng ChenMCMeng Chen
- Malin LiuMalin Liu
- Yaping TangYTYaping Tang
- 20 February 2019
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 17 (7)
Abstract
In this work, a comparative study of Euler-Euler and Euler-Lagrange approaches for modeling gas-solid flows in the multiple-spouted bed has been carried out to investigate the hydrodynamics of gas-solid flows. The influence of inlet gas velocity on the hydrodynamics of gas-solid flows in the multiple-spouted bed is investigated as well. Hydrodynamic characteristics of gas-solid flows such as flow behaviors, solid volume fraction, particle velocity and particle trajectory are analyzed and discussed in detail, providing some basic mechanism analysis of the gas-solids in the multiple-spouted bed. It is found that the central spout gas jet is a little confined by the auxiliary gas jets, and the hole-to-hole synergy is quite obvious when the auxiliary spout gas velocity is higher than the central spout gas velocity. When central/auxiliary gas velocity is 10/20 m/s, the maximum vertical particle velocities predicted by Euler-Euler and Euler-Lagrange approaches are 452 mm/s and 721 mm/s at the height of 10 mm respectively. A typical cycle period of a single particle is about 1.25 s, and the residence time in the spout regions is about 0.14 s in one cycle period in auxiliary dominant pattern. The curves of bed expansion height versus time calculated by Euler-Lagrange approach rise and fall periodically, while the curves calculated by Euler-Euler approach keep steady with little change. It is much easier for particles to be blew in the multiple-spouted bed using the Euler-Lagrange approach. The simulation results obtained from two models can provide some guidance for modifying the multiple-spouted bed to optimize physical operations such as drying and coating in the multiple-spouted bed.Keywords
This publication has 51 references indexed in Scilit:
- Comparison of the standard Euler–Euler and hybrid Euler–Lagrange approaches for modeling particle transport in a pilot-scale circulating fluidized bedParticuology, 2014
- Computational Fluid Dynamics (CFD)–Discrete Element Method (DEM) Simulation of Gas–Solid Turbulent Flow in a Cylindrical Spouted Bed with a Conical BaseEnergy & Fuels, 2011
- Numerical and experimental study on multiple-spout fluidized bedsChemical Engineering Science, 2011
- Fluid Dynamic Study of a Semicylindrical Spouted Bed: Evaluation of the Shear Stress Effects in the Flat Wall Region Using Computational Fluid DynamicsIndustrial & Engineering Chemistry Research, 2009
- Hot melt granulation of coarse pharmaceutical powders in a spouted bedPowder Technology, 2009
- Numerical simulation and experimental study of fluid–particle flows in a spouted bedPowder Technology, 2009
- Simulation of the Hydrodynamics and Drying in a Spouted Bed DryerDrying Technology, 2007
- Hydrodynamic characteristics of a rotating jet annular spouted bedPowder Technology, 1999
- Instability in the evolution equations describing incompressible granular flowJournal of Differential Equations, 1987
- MicromeriticsSoil Science, 1943