Dynamic Evolution of the Evaporating Liquid–Vapor Interface in Micropillar Arrays
- 4 January 2016
- journal article
- research article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 32 (2) , 519-526
Abstract
Capillary assisted passively pumped thermal management devices have gained importance due to their simple design and reduction in energy consumption. The performance of these devices is strongly dependent on the shape of the curved interface between the liquid and vapor phases. We developed a transient laser interferometry technique to investigate the evolution of the shape of the liquid-vapor interface in micropillar arrays during evaporation heat transfer. Controlled cylindrical micropillar arrays were fabricated on the front side of a silicon wafer, while thin-film heaters were deposited on the reverse side to emulate a heat source. The shape of the meniscus was determined using the fringe patterns resulting from interference of a monochromatic beam incident on the thin liquid layer. We studied the evolution of the shape of the meniscus on these surfaces under various operating conditions including varying the micropillar geometry and the applied heating power. By monitoring the transient behavior of the evaporating liquid-vapor interface, we accurately measured the absolute location and shape of the meniscus, and calculated the contact angle and the maximum capillary pressure. We demonstrated that the receding contact angle which determines the capillary pumping limit, is independent of the microstructure geometry and the rate of evaporation (i.e., the applied heating power). The results of this study provide fundamental insights into the dynamic behavior of the liquid-vapor interface in wick structures during phase-change heat transfer.Keywords
Funding Information
- Division of Graduate Education (1122374)
- Air Force Office of Scientific Research (FA9550-11-1-0059)
- Masdar Institute of Science and Technology (02/MI/MI/CP/11/07633/GEN/G/00)
- Massachusetts Institute of Technology (02/MI/MI/CP/11/07633/GEN/G/00)
- Office of Naval Research
- Singapore-MIT Alliance for Research and Technology Centre
This publication has 38 references indexed in Scilit:
- Reducing instability and enhancing critical heat flux using integrated micropillars in two-phase microchannel heat sinks2015
- Flow boiling phenomena in a single annular flow regime in microchannels (I): Characterization of flow boiling heat transferInternational Journal of Heat and Mass Transfer, 2014
- Experimental Characterization of Capillary-Fed Carbon Nanotube Vapor Chamber WicksJournal of Heat Transfer, 2012
- Enhanced Heat Transfer in Biporous Wicks in the Thin Liquid Film Evaporation and Boiling RegimesJournal of Heat Transfer, 2012
- Investigations of Biporous Wick Structure DryoutJournal of Heat Transfer, 2011
- Characterization of evaporation and boiling from sintered powder wicks fed by capillary actionInternational Journal of Heat and Mass Transfer, 2010
- Helping chips to keep their coolNature Nanotechnology, 2009
- Cooling a Microprocessor ChipProceedings of the IEEE, 2006
- Capillarity: Deformable Interfaces2004
- Analytical Model for Capillary Evaporation Limitation in Thin Porous LayersJournal of Thermophysics and Heat Transfer, 2003