Electrolyte-Insulator-Semiconductor field effect device for pH detecting
Authors:
- 1 September 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
This work presents a device for pH measurements called Electrolyte-Insulator-Semiconductor (EIS), which operates as a Metal-Oxide-Semiconductor capacitor but instead of having the metal contact electrode, an electrolyte solution and a reference electrode are used to apply voltage. It was used TiO 2 thin film as insulator and sensitive membrane. These films were obtained after rapid thermal oxidation of Ti thin films deposited by sputtering. They were structurally characterized by Raman and ellipsometry which reveal that the films present rutile crystal structure. We use capacitors to make the electrical characterization of TiO 2 films in order to determine the annealing time that leads to the best thin film properties, defined by high dielectric constant value (high-k), lower charge density (Q 0 /q) and flat-band voltage (V FB ) around -0.9V. EIS devices are tested through capacitance x voltage (CxV) measurements using different pH solutions. When in contact to the dielectric film, each pH value adds a contribution to the flat band voltage, resulting in a displacement of the CxV curve. It was possible to determine from the flat band voltage (V FB ), the sensitivity of 41 mV/pH.Keywords
This publication has 11 references indexed in Scilit:
- Very low drift and high sensitivity of nanocrystal-TiO2 sensing membrane on pH-ISFET fabricated by CMOS compatible processApplied Surface Science, 2013
- Preparation and characterization of high‐k aluminium nitride (AlN) thin film for sensor and integrated circuits applicationsphysica status solidi (c), 2012
- Glucose biosensor of ruthenium-doped TiO2 sensing electrode by co-sputtering systemMicroelectronics Reliability, 2010
- Oxygen migration in TiO2-based higher-k gate stacksJournal of Applied Physics, 2010
- Scaling the MOSFET gate dielectric: From high-k to higher-k? (Invited Paper)Microelectronic Engineering, 2009
- Study on pH at the point of zero charge of TiO2 pH ion-sensitive field effect transistor made by the sputtering methodThin Solid Films, 2005
- The surface science of titanium dioxideSurface Science Reports, 2003
- High-κ gate dielectrics: Current status and materials properties considerationsJournal of Applied Physics, 2001
- Estimating oxide thickness of tunnel oxides down to 1.4 nm using conventional capacitance-voltage measurements on MOS capacitorsIEEE Electron Device Letters, 1999
- Characterization of ultra-thin oxides using electrical C-V and I-V measurements1998