Numerical Assessment of Emission Sources for a Modified Diesel Engine Running in PCCI Mode on a Mixture of Gasoline and Diesel
Authors:
- 11 September 2011
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Premixed charge compression ignition (PCCI) is an interesting alternative to conventional diesel combustion, as it allows very low emission levels for part load operation. The difficult control of the onset of combustion is an obstacle to the implementation of PCCI. In a recent study, different mixtures of gasoline and diesel fuel have been used in a modified diesel engine to delay the ignition and thus to allow for a substantial premixing time. For these cases, very low levels of particulate emissions have been reported. However, the emissions of CO and NOx were considerably high.In this study, combustion and pollutant formation in the above-mentioned modified diesel engine are simulated using the representative interactive flamelet (RIF) approach. A detailed chemical reaction mechanism for a mixture of n-heptane, iso-octane, toluene, and ethanol, serving as surrogate fuel for the diesel-gasoline blend, is used for the simulations. By systematic comparison of experimental and numerical results, an improved understanding of PCCI combustion is achieved and the origins of the CO and NOx emissions are identified. Finally, measures to reduce these emissions while keeping the low PM levels are suggested.Keywords
This publication has 28 references indexed in Scilit:
- Advanced compression-ignition engines—understanding the in-cylinder processesProceedings of the Combustion Institute, 2009
- Computational Methods for Fluid Dynamics2002
- Computational fluid dynamics modelling of non-premixed combustion in direct injection diesel enginesInternational Journal of Engine Research, 2000
- Simulation of combustion in direct injection diesel engines using a eulerian particle flamelet modelProceedings of the Combustion Institute, 2000
- Modeling the Combustion in a Small-Bore Diesel Engine Using a Method Based on Representative Interactive FlameletsSAE International Journal of Advances and Current Practices in Mobility, 1999
- Modelling the Effect of Split Injections in Diesel Engines Using Representative Interactive FlameletsSAE International Journal of Advances and Current Practices in Mobility, 1999
- 3d Simulation of Di Diesel Combustion and Pollutant Formation Using a Two-Component Reference FuelOil & Gas Science and Technology – Revue d’IFP Energies nouvelles, 1999
- The Effects of Mixture Formation on Premixed Lean Diesel Combustion EngineSAE International Journal of Advances and Current Practices in Mobility, 1998
- Reduced mechanisms for NOx emissions from hydrocarbon diffusion flamesSymposium (International) on Combustion, 1996
- On the modeling of scalar diffusion in isotropic turbulencePhysics of Fluids A: Fluid Dynamics, 1992