Simulation of a Multistaggered Baffle Scrubber to Enhance the Efficiency of Simultaneous Desulfurization and Denitrification
Open Access
- 18 March 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (13) , 15372-15382
Abstract
In this study, we conduct simulation research on simultaneous desulfurization and denitrification in a multistaggered baffle spray scrubber. By employing two-phase flow simulations within the Euler–Lagrange framework and calculating the gas–liquid mass transfer rate with user-defined functions, we comprehensively analyzed the effects of various operational parameters. Initially, we validated our simulation model by comparing the simulation results with experimental data. Under conditions of a 0.2 mm droplet diameter, a liquid-to-gas ratio (L/G) of 12 L/m3, and a gas flow rate of 5 CMM using a full cone nozzle, the simulation indicated a desulfurization efficiency of 99.90 versus 99.84% obtained experimentally and a denitrification efficiency of 92.01 versus 90.67% obtained experimentally. This comparison confirmed the reliability of the simulation model. Our findings indicate that a droplet size of 2 mm is optimal, enhancing the desulfurization efficiency from 99.90 to 99.98% and the denitrification efficiency from 92.01 to 99.76%. However, when the droplet size exceeds 2 mm, efficiencies marginally decrease. Increasing the liquid-to-gas ratio to 16 L/m3 further improves desulfurization and denitrification efficiencies to 99.98 and 99.80%, respectively. In contrast, higher inlet flue gas flow rates reduce these efficiencies, with a decline observed from 100% to as low as 93.90% for denitrification with 2 mm droplets. Additionally, the use of a swirl cone nozzle, compared to full or hollow cone nozzles, better disperses droplets, enhancing the gas–liquid contact and achieving efficiencies of 99.99% for desulfurization and 99.81% for denitrification with 2 mm droplets. These insights are valuable for optimizing operational conditions in industrial-scale spray scrubbers, significantly contributing to mitigating the environmental impacts of industrial emissions.Keywords
Funding Information
- National Research Foundation of Korea
- Ministry of Science, ICT and Future Planning (2022K1A4A8A01080312)
- Ministry of Environment (2020003060005)
This publication has 39 references indexed in Scilit:
- Mass transfer process intensification for SO2 absorption in a commercial-scale wet flue gas desulfurization scrubberChemical Engineering and Processing - Process Intensification, 2021
- Recent advances in hybrid wet scrubbing techniques for NOx and SO2 removal: State of the art and future researchChemosphere, 2021
- A numerical study of the ammonia desulfurization in the spray scattering towerChemical Engineering and Processing - Process Intensification, 2020
- Study on efficient removal of SOx and NOx from marine exhaust gas by wet scrubbing method using urea peroxide solutionChemical Engineering Journal, 2020
- A critical review on the method of simultaneous removal of multi-air-pollutant in flue gasChemical Engineering Journal, 2019
- Synergistic effect between spraying layers on the performance of the WFGD spray columnAsia-Pacific Journal of Chemical Engineering, 2018
- Electron Beam Technology for Environmental Pollution ControlTopics in Current Chemistry, 2016
- Numerical simulation of NO2 absorption using sodium sulfite in a spray towerJournal of Chemical Technology & Biotechnology, 2015
- Measurement of slurry droplets in coal-fired flue gas after WFGDEnvironmental Geochemistry and Health, 2014
- Effects of nitrogen dioxide on pulmonary function in human subjects: An environmental chamber studyEnvironmental Research, 1979