Optimisation of nanocomposites based on polypropylene/polyethylene blends and organo-bentonite
- 21 October 2003
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 13 (12) , 2915-2921
Abstract
The effect of the organophilisation of a Na-bentonite, through cationic exchange reaction with a commercial quaternary benzalkonium salt, on the morphology and mechanical behaviour of polypropylene (PP)/low density polyethylene (LDPE) blend matrices has been investigated employing a statistical experimental design. The results show that the tensile modulus and strength of the composites increase (up to 760 and 360%, respectively) as both PP percentage in the matrix and clay content in the composite increase. The properties are more dependent on matrix composition than on clay content. In all cases, the organo-bentonite gives rise to more resistant materials in comparison with the Na-bentonite. Increments of 50–35% in stiffness and strength, respectively, have been observed. The elongation at break mainly depends on matrix composition and a minimum is observed when phase inversion has taken place. The organophilized bentonite gives rise, in some formulations, to an increase in elongation up to 400%. Theoretical equations to predict the tensile behaviour of composites based on PP/LDPE blends with Na-bentonite and benzalkoniun chloride modified bentonite, inside the investigated limits, have been deduced. A morphological study has been carried out by means of scanning electron microscopy.Keywords
This publication has 23 references indexed in Scilit:
- Preparation and characterization of organoclay nanocomposites based on natural rubberPolymer International, 2003
- Morphology and physical properties of polyethylene/silicate nanocomposite prepared by melt intercalationJournal of Polymer Science Part B: Polymer Physics, 2002
- Preparation of TiB2 powders by mechanical alloyingMaterials Letters, 2002
- Effect of the incorporation of pet fibers on the properties of thermoplastic elastomer based on PP/elastomer blendsPolymer, 2001
- Lattice Model of Polymer Melt Intercalation in Organically-Modified Layered SilicatesMacromolecules, 1997
- Preparation and Mechanical Properties of Polypropylene−Clay HybridsMacromolecules, 1997
- Mechanical properties of nylon 6-clay hybridJournal of Materials Research, 1993
- Effect of talc surface treatment on the mechanical properties of composites based on PP/LDPE blend matricesPolymer Engineering & Science, 1991
- Polypropylene/low density polyethylene blends with short glass fibers. II: Effect of compounding method on mechanical propertiesPolymer Composites, 1991
- Uniform Shell DesignsJournal of the Royal Statistical Society Series C: Applied Statistics, 1970