Influence of the electrode and the pH on the rate and the product distribution of the electrochemical removal of nitrate
- 1 February 2013
- journal article
- research article
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (3) , 373-381
Abstract
The effect of the nature of six metal electrodes (Sn, Bi, Pb, Al, Zn, In) on the rate and the distribution of the products of the electrochemical reduction of nitrate was studied. The product distribution depends on the nature of the metal only quantitatively, while the rate of the reduction was found to be about the same on all metals when the electrolysis was performed at the same rational potential (Er), which is the difference between the applied potential and the potential of zero charge of each metal. Based on these results it was concluded that the mechanism of nitrate reduction is the same for all cathodes studied. Additionally, the influence of the initial pH on the rate of the reduction of nitrate and the selectivity of the products on a tin cathode was studied. The rate of the reduction increases linearly with the concentration of hydronium ion in the pH range 0–4, whereas it is not dependent on the pH at higher pH values. The main products at pH>4 were nitrogen, nitrous oxide, ammonia and nitrite, while at pH 0–4 ammonia and hydroxylamine were mainly formed.Keywords
This publication has 56 references indexed in Scilit:
- Optimization of the cathode material for nitrate removal by a paired electrolysis processJournal of Hazardous Materials, 2011
- Removal of nitrates by electrolysis in non-chloride media: Effect of the anode materialSeparation and Purification Technology, 2011
- Electrochemical treatment of wastewater polluted by nitrate: selective reduction to N2 on Boron-Doped Diamond cathodeWater Science & Technology, 2011
- Nitrate removal by a paired electrolysis on copper and Ti/IrO2 coupled electrodes – Influence of the anode/cathode surface area ratioWater Research, 2010
- Simultaneous reduction of nitrate and oxidation of by-products using electrochemical methodJournal of Hazardous Materials, 2009
- Two-stage Sequential Electrochemical Treatment of Nitrate Brine WastesWater, Air, & Soil Pollution: Focus, 2007
- Electrocatalytic activity of copper alloys for NO−3 reduction in a weakly alkaline solutionJournal of Applied Electrochemistry, 2007
- Electrochemical denitrificaton of simulated ground waterWater Research, 2005
- Application of a solid polymer electrolyte reactor to remove nitrate ions from wastewaterJournal of Applied Electrochemistry, 2005
- Paired electrolysis in a solid polymer electrolyte reactor—Simultaneously reduction of nitrate and oxidation of ammoniaChemical Engineering Journal, 2005