Pitting Corrosion Resistance of Martensite of AISI 1045 Steel and the Beneficial Role of Interstitial Carbon
Open Access
- 22 November 2017
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (14) , C962-C972
Abstract
The pitting corrosion resistance of AISI 1045 carbon steel with as-quenched, tempered, and low-carbon martensitic microstructures was investigated in boric-borate buffer solutions with and without NaCl. Analysis by micro-scale polarization found that tempering and decarburizing treatments decreased the pitting corrosion resistance of as-quenched martensite. The high corrosion resistance of the as-quenched martensite was likely due to the large amount of interstitial carbon. The pitting corrosion resistances of as-quenched martensite, primary ferrite, and pearlite were compared using micro-scale polarization measurements. It was determined that the pitting corrosion resistances of the typical steel structures were ordered as follows: (high) as-quenched martensite > tempered martensite ≈ primary ferrite > pearlite (low). The pitting corrosion resistance of steel was shown to depend on its microstructure.Keywords
This publication has 36 references indexed in Scilit:
- Enhanced corrosion resistance of interstitially hardened stainless steel: Implications of a critical passive layer thickness for breakdownActa Materialia, 2012
- Depth-profiling electrochemical measurements of low temperature plasma carburised 316L stainless steel in 1M H2SO4 solutionSurface and Coatings Technology, 2010
- Carburization-Enhanced Passivity of PH13-8 Mo: A Precipitation-Hardened Martensitic Stainless SteelElectrochemical and Solid-State Letters, 2010
- Enhanced Corrosion Resistance of Stainless Steel Carburized at Low TemperatureMetallurgical and Materials Transactions A, 2009
- Microstructural influence on the electrochemical corrosion behaviour of dual-phase steels in 3.5% NaCl solutionMaterials Letters, 2005
- A new microelectrochemical method to study pit initiation on stainless steelsElectrochimica Acta, 1997
- Electrochemical properties of Fe and steelCorrosion Science, 1969
- Effect of Cold-Work on Corrosion of Iron and Steel in Hydrochloric AcidJournal of the Electrochemical Society, 1964
- The Effect of Alloying Elements in Iron on Hydrogen Over-voltage and Corrosion Rate in Acid EnvironmentsJournal of the Electrochemical Society, 1955
- Dislocation Theory of Yielding and Strain Ageing of IronProceedings of the Physical Society. Section A, 1949