Thermal Analysis of a Constant Temperature Pirani Gauge Based on Micro-hotplate
Authors:
- 1 January 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1072-1075
Abstract
A micro-hotplate (MHP) based Pirani gauge is fabricated using surface-micromachining technology and measured with a typical constant temperature circuit. The measured results show that its sensitive range is at least 10-105 Pa and can be widen when increasing working temperature. According to Fourier method and energy conservation law, heat conduction differential equations of the supporting beams are built and solved to determine the temperature distribution along the beams and heat losses through solid heat conduction at different pressure. Other heat loss mechanisms of the MHP square membrane are also investigated and it has proven that heat losses through solid heat conduction in micro Pirani increase with gas pressure at constant temperature, whereas they were always considered to be independent of gas pressure in previous studiesKeywords
This publication has 9 references indexed in Scilit:
- A micro-Pirani vacuum gauge based on micro-hotplate technologySensors and Actuators A: Physical, 2006
- Process-dependent Thermophysical Properties Of CMOS IC Thin Films2005
- A flow direction sensor fabricated using MEMS technology and its simple interface circuitSensors and Actuators B: Chemical, 2003
- CMOS electrothermal microactuators2002
- Thermal measurement and analysis of micro hotplate array using thermographySensors and Actuators A: Physical, 2002
- A low-power CMOS compatible integrated gas sensor using maskless tin oxide sputteringSensors and Actuators B: Chemical, 1998
- Theory and experiments on r.f. sputtered tin oxide thin-films for gas sensing applicationsSensors and Actuators B: Chemical, 1997
- Miniaturized thin film thermal vacuum sensorJournal of Vacuum Science & Technology A, 1995
- Numerical modeling of a micromachined thermal conductivity gas pressure sensorIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 1994