Austenitization and formation of ausferrite structure in austempered ductile iron with dual matrix
Open Access
- 1 April 2022
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (4) , 046520
Abstract
The effect of austenitizing conditions on the microstructure and mechanical properties of an austempered ductile iron (ADI) with a dual matrix was investigated. Carbon diffusion plays a critical role in the phase transformation of austenitization. In initially pearlitic structures, the carbon diffusion distances involved during austenitization are smaller compared to those in ferritic structures. The study was carried out to examine the influence of temperature and times of the austenitization process on the maximum carbon content in austenite and then its effect on the processing window of ADI with the dual matrix. An alloyed ductile iron (3,6%C; 2,44%Si; 0,36%Mn; 0,9%Ni; 0,61%Cu; 0,11%Cr; 0,036%Mg; 0,015%S và 0,006%P) was fully austenitic at various temperatures 870 °C–930 °C. The minimum hardness reaches the value of 270 HB. An increase in austenitization temperature increases the carbon content dissolved in the austenite, which in turn, decreases the free energy controlling the transformation of austenite to bainite ferrite and high carbon austenite. Raising the austenitization temperature makes the process window shift toward the extending time. The carbon atoms must diffuse out of the ferrite needle with a diffusion distance equal to the ferrite layer thickness. At 360 °C austempered temperature, diffusion coefficient D = 4.60.10–17(m2/s). With a ferrite needle thickness of 1μm = 10–6 m, the diffusion time would be t = 5330 (s).Keywords
Funding Information
- School of Mechanical Engineering, Vietnam Maritime University
- HUST
This publication has 19 references indexed in Scilit:
- Austempering heat treatment of ductile iron: Computational simulation and experimental validationFinite Elements in Analysis and Design, 2017
- Assessment of the microstructure evolution of an austempered ductile iron during austempering process through strain hardening analysisMetals and Materials International, 2017
- Characteristics of the Transformation of Retained Austenite in Tempered Austempered Ductile IronJournal of Materials Engineering and Performance, 2017
- Mechanical Characterization of Austempered Ductile Iron Obtained by Two Step Austempering ProcessTransactions of the Indian Institute of Metals, 2017
- A Microscale Model for Ausferritic Transformation of Austempered Ductile IronsMetallurgical and Materials Transactions A, 2016
- Kinetics of the Bainite Transformation in Austempered Ductile Iron ADIAdvances in Materials Science, 2016
- Nucleation and Growth of Graphite in Eutectic Spheroidal Cast Iron: Modeling and TestingMetallurgical and Materials Transactions A, 2016
- Microstructure and phase transformation of wear resistant ductile iron grinding balls by continuous cooling processMaterials Science and Engineering: A, 2015
- Development of as-cast dual matrix structure (DMS) ductile ironMaterials Science and Engineering: A, 2013
- Effect of ausferrite volume fraction and morphology on tensile properties of partially austenitised and austempered ductile irons with dual matrix structuresInternational Journal of Cast Metals Research, 2007