Effect of high pulling speeds on the morphologies of pultrudates in a thermoplastic pultrusion process
- 3 October 2022
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 36 (9) , 3566-3584
Abstract
During thermoplastic pultrusion, increasing the pulling speed generally leads to a melted polymer pressure rise in the pultrusion dies. Yet, it was not clear if the polymer pressure’s increase would result in a faster impregnation flow that would compensate for the lower residency time inside the heating dies. Thus, the aim of this study was to verify if the speed-induced pressure can counterbalance the decrease in residency time that is required for impregnation quality and to analyze possible pultrudate morphology’s reconfiguration. Three distant pulling speeds were selected: namely 50, 500 and 1000 mm/min. Using a model, the polymer pressure in the pultrusion dies was computed to reach up to 1.0, 10.42, and 20.6 MPa for the respective pultrusion pulling speed. The morphology’s characterization showed a reconfiguration of the pultrudate at a higher pulling speed leading to larger unimpregnated agglomerations and polymer rich areas. The highest tensile strength achieved was 233.4 ± 1.5 MPa at 50 mm/min and dropped by around 20% when the pulling speed was raised to 1000 mm/min. The pultrudate reconfiguration at higher speed, attributed to delayed melting of PP fibers in underfilled dies, is deemed responsible for the loss in impregnation and mechanical properties.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada (CRDPJ488387-15)
- PRIMA Québec (R10-009)
- Saudi Arabia’s Saline Water Conversion Corporation and Ministry of Education (KSP12014087)
This publication has 25 references indexed in Scilit:
- Permeability Measurement Methods in Porous Media of Fiber Reinforced CompositesApplied Mechanics Reviews, 2010
- Effect of nanosized and surface-modified precipitated calcium carbonate on properties of CaCO3/polypropylene nanocompositesMaterials Science and Engineering: A, 2009
- Characteristics of hemicellulose, cellulose and lignin pyrolysisFuel, 2007
- Design and Development of a Long Fiber Thermoplastic Bus SeatJournal of Thermoplastic Composite Materials, 2006
- An Experimental Study of the Pultrusion of Carbon Fiber-Polyamide 12 YarnJournal of Thermoplastic Composite Materials, 2006
- Pultrusion of Thermoplastic Composites - New Developments and Modelling StudiesJournal of Thermoplastic Composite Materials, 2002
- Thermoplastic pultrusion of natural fibre reinforced compositesComposite Structures, 2001
- A model for a thermoplastic pultrusion process using commingled yarnsComposites Science and Technology, 2001
- Processing of short‐fiber reinforced polypropylene. I. Influence of processing conditions on the morphology of extruded filamentsPolymer Engineering & Science, 2000
- Experimental investigation of pultrusion of glass fibre reinforced polypropylene compositesComposites Part A: Applied Science and Manufacturing, 1998