A model for parison behavior in the extrusion blow molding process
Authors:
- 1 May 1985
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 31 (5) , 807-811
Abstract
A simple, lumped‐parameter model has been developed to predict the length and shape of a parison on the basis of experimental swell data and the storage modulus of the resin. The applicability and limitations of the model are demonstrated by comparing its predictions with experimental observations of parison behavior.Keywords
This publication has 10 references indexed in Scilit:
- Isothermal swell of extrudate from annular dies; effects of die geometry, flow rate, and resin characteristicsPolymer Engineering & Science, 1984
- Swell of extrudate from an annular diePolymer Engineering & Science, 1982
- A study of parison development in extrusion blow moldingJournal of Non-Newtonian Fluid Mechanics, 1982
- Measurement and calculation of parison dimensions and bottle thickness distribution during blow moldingPolymer Engineering & Science, 1981
- Structural time dependency in the rheological behavior of molten polymersJournal of Applied Polymer Science, 1981
- Determination of rheological parameters from parison extrusion experimentsPolymer Engineering & Science, 1978
- A non-linear viscoelastic model with structure-dependent relaxation timesJournal of Non-Newtonian Fluid Mechanics, 1976
- Variables affecting parison diameter swell and their correlation with rheological parametersPolymer Engineering & Science, 1973
- A general method for the determination of approximations to the spectral distributions from the dynamic response functionsRheologica Acta, 1973
- A general method for the determination of appproximations to the spectral distributions from the dynamic response functionsRheologica Acta, 1971