CFD–PBM Simulation on Bubble Size Distribution in a Gas–Liquid–Solid Flow Three-Phase Flow Stirred Tank
Open Access
- 5 January 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (2) , 1934-1942
Abstract
The bubble size distribution, location distribution, and gas holdup in a gas–liquid–solid flow three-phase stirred tank were numerically simulated by the Eulerian–Eulerian method and the population balance model (PBM). The Euler–Euler method combined with the PBM model included the influence of bubble aggregation and fragmentation on the interfacial force, which can better predict the bubble size distribution and phase holdups. The simulation results show that there are some differences in the fluid morphology and gas dispersion characteristics in the stirred tank under different rotating speeds. With the increase of rotating speed, the content of small-diameter bubbles increases obviously, and they are mainly concentrated in areas with higher speeds. The higher the rotational speed, the more the bubbles with small diameters, but the content of bubbles with large diameters is less affected by the rotational speed. Small-size bubbles mainly exist in the region of high fluid velocity, while large-size bubbles mainly exist in the region of low hydrostatic pressure. Compared with the change of the bubble content at different speeds, the content of bubbles with diameters of 0.50–1.90 mm is largest at 2000 rpm, while the content of bubbles with diameters of 2.65–10.09 mm is largest at 1500 rpm. The simulation work has certain guiding significance for the research and development of the forced mineralization device and the understanding of the dispersion characteristics of bubbles in the stirred tank.Keywords
Funding Information
- State Key Laboratory of Mineral Processing (BGRIMM-KJSKL-2020-14)
This publication has 25 references indexed in Scilit:
- Multidimensional population balance model for the simulation of turbulent gas–liquid systems in stirred tank reactorsChemical Engineering Science, 2012
- Numerical simulations of gas–liquid mass transfer in bubble columns with a CFD–PBM coupled modelChemical Engineering Science, 2007
- Modelling local bubble size distributions in agitated vesselsChemical Engineering Science, 2007
- Validation of bubble breakage, coalescence and mass transfer models for gas–liquid dispersion in agitated vesselChemical Engineering Science, 2006
- A CFD–PBM coupled model for gas–liquid flowsAIChE Journal, 2005
- Bubble‐Size distributions and flow fields in bubble columnsAIChE Journal, 2002
- Bubble size in aerated stirred tanksChemical Engineering Journal, 2002
- CFD Study of Homogenization with Dual Rushton Turbines—Comparison with Experimental ResultsChemical Engineering Research and Design, 2000
- A comparative study of two-phase flow models relevant to bubble column dynamicsJournal of Fluid Mechanics, 1999
- Analogous description of the hydrodynamics of gas-solid fluidized beds and bubble columnsThe Chemical Engineering Journal and the Biochemical Engineering Journal, 1993