Audit of Fuel Utilisation During the Warm-Up of SI Engines
Authors:
- 1 May 1997
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Experimental studies of fuel utilisation during the early stages of engine warm-up after cold-starts are reported. The investigation has been carried out on a 1.81, 4 cylinder spark-ignition engine with port electronic fuel injection. The relationship between fuel supplied and fuel accounted for by the analysis of exhaust gas composition shows that a significant mass of fuel supplied is temporarily stored or permanently lost. An interpretation of data is made which allows time-dependent variations of these to be separately resolved and estimates of fuel quantities made. The data covers a range of cold-start conditions down to -5°C at which, on a per cylinder basis, fuel stored peaks typically at around 0.75g and a total of 1g is returned over 100 seconds of engine running. Fuel lost past the piston typically accounts for 2g over 200 to 300 seconds of running. Fuel stored is poorly mixed on return to the bulk mixture and passes into the exhaust system primarily as unburned hydrocarbons. A UEGO sensor in the exhaust gas stream (and by implication a HEGO sensor) records mixture AFR's which are lean of the overall AFR deduced by exhaust gas analysis. Correction functions based on exhaust gas hydrocarbon composition content and start temperature have been defined. During warm-up, mixture control based on HEGO feedback information will provide fuel-rich rather than stoichiometric exhaust products composition. This will adversely effect catalytic converter efficiency even if early light-off conditions are achieved.Keywords
This publication has 10 references indexed in Scilit:
- Intake Port Fuel Transport and Emissions: The Influence of Injector Type and Fuel CompositionSAE International Journal of Advances and Current Practices in Mobility, 1996
- High-Speed Photography and Image Analysis Techniques Applied to Study Droplet Motion within the Porting and Cylinder of a 4-Valve SI EngineSAE International Journal of Advances and Current Practices in Mobility, 1995
- Analysis of Fuel Behavior in the Spark-Ignition Engine Start-Up ProcessSAE International Journal of Advances and Current Practices in Mobility, 1995
- Mixture Preparation and HC Emissions of a 4-Valve Engine with Port Fuel Injection During Cold Starting and Warm-upSAE International Journal of Advances and Current Practices in Mobility, 1995
- Fuel Transport Characteristics of Spark Ignition Engines for Transient Fuel CompensationSAE International Journal of Advances and Current Practices in Mobility, 1995
- A New Method to Analyze Fuel Behavior in a Spark Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 1995
- Liquid Gasoline Behavior in the Engine Cylinder of a SI EngineSAE International Journal of Advances and Current Practices in Mobility, 1994
- Universal Air-Fuel Ratio Heated Exhaust Gas Oxygen Sensor and Further ApplicationsSAE International Journal of Advances and Current Practices in Mobility, 1992
- Transient A/F Control Characteristics of the 5 Liter Central Fuel Injection EngineSAE International Journal of Advances and Current Practices in Mobility, 1981
- Transient Mixture Strength Excursions - An Investigation of Their Causes and the Development of a Constant Mixture Strength Fueling StrategySAE International Journal of Advances and Current Practices in Mobility, 1981