Pole tip recession in linear tape heads: Measurement technique and influence of head materials, tape speed and tape tension
Authors:
- 1 February 1999
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 213 (2) , 139-150
Abstract
Pole tip recession (PTR) in linear tape heads causes an increase in spacing and consequently an increase in signal loss. In this study, PTR in linear tape drives is analysed. Functional drive tests are conducted using thin-film Al2O3-TiC and Ni-Zn ferrite heads sliding against metal particle tape. Atomic force microscopy is used to measure PTR and the recession of the overcoat material used in the construction of the head. In measuring PTR, care must be taken in correctly orienting the stand-alone atomic force microscope tip with respect to the head sample. Care must also be taken in post-processing the raw stand-alone atomic force microscopy data. Based on PTR data with Al2O3-TiC and Ni-Zn ferrite heads, no significant differences exist in the PTR of Al2O3-TiC heads compared with Ni-Zn ferrite heads. In the case of the Ni-Zn ferrite head, the softer Ni-Zn ferrite substrate has mechanical properties close to those of the poles, suggesting that PTR growth should be low. However, additional third-body wear particles from the ferrite substrate result in additional pole tip wear. No significant difference is seen in the wear of Co-Zr-Ta poles and Ni-Fe poles, as they have comparable mechanical properties. No strong conclusion may be drawn about the effect of tape speed on PTR. An increase in tape tension leads to an increase in PTR. This is a result of an increase in the normal force, which causes an increase in the abrasive wear. An increase in interface contamination also leads to an increase in PTR.Keywords
This publication has 15 references indexed in Scilit:
- Tribological studies of chromium oxide films for magnetic recording applicationsThin Solid Films, 1997
- Micromechanical and tribological characterization of alternate pole tip materials for magnetic recording headsWear, 1996
- Pole tip recession studies of hard carbon-coated thin-film tape headsJournal of Applied Physics, 1996
- Tribology and Mechanics of Magnetic Storage Devices1996
- Alternate pole materials for MR tape headsIEEE Transactions on Magnetics, 1996
- Metal Core Recession and Head Stain Studies of MIG Heads Sliding against Cobalt-Doped Gamma Iron Oxide and Metal Particle TapesTribology Transactions, 1995
- Wear and corrosion resistance of Fe-N based micrograin soft magnetic thin filmsIEEE Transactions on Magnetics, 1994
- Relation between spacing losses and level differences in laminated film headsIEEE Transactions on Magnetics, 1993
- Level differences in hybrid heads after contact with various tapesIEEE Transactions on Magnetics, 1990
- Khruschov's rule and the abrasive wear resistance of multiphase solidsWear, 1982