Comparison of Nonlinear Static Methods for the Seismic Assessment of Plan Irregular Frame Buildings with Non Seismic Details
- 28 December 2011
- journal article
- research article
- Published by Taylor & Francis in Journal of Earthquake Engineering
- Vol. 16 (1) , 15-39
Abstract
The use of Nonlinear Static Procedures (NSPs) for the seismic assessment of plan irregular buildings is challenging. The most common pushover-based approaches have led to adequate results in regular buildings, and hence, there is a need to verify the validity of such methods on the assessment of irregular structures. In this article, four commonly used nonlinear static procedures (CSM, N2, MPA, ACSM) are applied on the assessment of two existing five- and eight-story plan-asymmetric buildings in Turkey. The accuracy of the different NSPs is evaluated through comparisons with the results derived from nonlinear dynamic analyses. The results are presented in terms of interstory drifts, normalized top displacements, lateral displacement profiles, chord rotations, base shear, and top displacement ratios. The performance of such procedures in evaluating the damage limitation according to the Eurocode8 is also verified. Special attention is given to the ACSM (Adaptive Capacity Spectrum Method) whose performance in 3D plan irregular buildings has recently been tested. Conclusions about the performance of each NSP are outlined at the end of the article.Keywords
This publication has 14 references indexed in Scilit:
- Using nonlinear static procedures for seismic assessment of the 3D irregular SPEAR buildingEarthquakes and Structures, 2010
- Detailed assessment of structural characteristics of Turkish RC building stock for loss assessment modelsSoil Dynamics and Earthquake Engineering, 2008
- An adaptive capacity spectrum method for assessment of bridges subjected to earthquake actionBulletin of Earthquake Engineering, 2007
- DEVELOPMENT AND VERIFICATION OF A DISPLACEMENT-BASED ADAPTIVE PUSHOVER PROCEDUREJournal of Earthquake Engineering, 2004
- A modal pushover analysis procedure to estimate seismic demands for unsymmetric‐plan buildingsEarthquake Engineering & Structural Dynamics, 2004
- Study on Damping Reduction Factor for Buildings under Earthquake Ground MotionsJournal of Structural Engineering, 2003
- A modal pushover analysis procedure for estimating seismic demands for buildingsEarthquake Engineering & Structural Dynamics, 2001
- A Nonlinear Analysis Method for Performance‐Based Seismic DesignEarthquake Spectra, 2000
- Theoretical Stress‐Strain Model for Confined ConcreteJournal of Structural Engineering, 1988
- Modeling of R/C Joints under Cyclic ExcitationsJournal of Structural Engineering, 1983