Principle and Design of a Single-Phase Inverter-Based Grounding System for Neutral-to-Ground Voltage Compensation in Distribution Networks
- 21 September 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 64 (2) , 1204-1213
Abstract
Neutral-to-ground overvoltage may occur in noneffectively grounded power systems because of the distributed parameters asymmetry and resonance between Petersen coil and distributed capacitances. Thus, the constraint of neutral-to-ground voltage is critical for the safety of distribution networks. In this paper, an active grounding system based on a single-phase inverter and its control parameter design method is proposed to achieve this objective. Relationship between its output current and neutral-to-ground voltage is derived to explain the principle of neutral-to-ground voltage compensation. Then, a practical current detection method is proposed to specify the reference of compensated current. A current control method consisting of proportional resonant and proportional integral (PI) with capacitive current feedback is then proposed to guarantee sufficient output current accuracy and stability margin subjecting to large range of load change. The PI method is taken as the comparative method and the performances of both control methods are presented in detail. Experimental results prove the effectiveness and novelty of the proposed grounding system and control method.Keywords
Funding Information
- National Natural Science Foundation of China (51407014, 51425701)
- Hunan Provincial Natural Science Foundation of China (2015JJ3009)
- Hunan Provincial Department of Education (15B007)
This publication has 19 references indexed in Scilit:
- Proportional-Resonant Current Controllers Design Based on Desired Transient PerformanceIEEE Transactions on Power Electronics, 2015
- Analysis of the Passive Damping Losses in LCL-Filter-Based Grid ConvertersIEEE Transactions on Power Electronics, 2012
- A New Design Method for the Passive Damped LCL and LLCL Filter-Based Single-Phase Grid-Tied InverterIEEE Transactions on Industrial Electronics, 2012
- On Zero Steady-State Error Voltage Control of Single-Phase PWM Inverters With Different Load TypesIEEE Transactions on Power Electronics, 2011
- A Novel Method of Measuring Inherent Power System Charging CurrentIEEE Transactions on Industry Applications, 2011
- Generalized Design of High Performance Shunt Active Power Filter With Output LCL FilterIEEE Transactions on Industrial Electronics, 2011
- A New Feedback Method for PR Current Control of LCL-Filter-Based Grid-Connected InverterIEEE Transactions on Industrial Electronics, 2010
- Parameter Design of a Two-Current-Loop Controller Used in a Grid-Connected Inverter System With LCL FilterIEEE Transactions on Industrial Electronics, 2009
- Identifying Single-Phase-to-Ground Fault Feeder in Neutral Noneffectively Grounded Distribution System Using Wavelet TransformIEEE Transactions on Power Delivery, 2008
- Stability of photovoltaic and wind turbine grid-connected inverters for a large set of grid impedance valuesIEEE Transactions on Power Electronics, 2006