3D Modelling of Layer-by-Layer Heat and Mass Transfer in Wire Arc Additive Manufacturing
Authors:
- Yan LiYLYan Li
- Ze YunZYZe Yun
- Wutong ZhangWZWutong Zhang
- Xun LongXLXun Long
- Jianjun ZhuJZJianjun Zhu
Open Access
- 14 July 2024
- journal article
- research article
- Published by Elsevier in Additive Manufacturing Frontiers
- Vol. 3 (3)
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China
This publication has 28 references indexed in Scilit:
- Development of a basic technology for multilayer electron beam cladding of Inconel 718 nickel-based alloy onto an austenitic stainless steelCIRP Journal of Manufacturing Science and Technology, 2022
- Real-time observation and numerical simulation of the molten pool flow and mass transfer behavior during wire arc additive manufacturingWelding in the World, 2021
- Control of deposition height in WAAM using visual inspection of previous and current layersJournal of Intelligent Manufacturing, 2020
- Effect of heat input on microstructure and mechanical properties of Al-Mg alloys fabricated by WAAMApplied Surface Science, 2019
- Heat source management in wire-arc additive manufacturing process for Al-Mg and Al-Si alloysAdditive Manufacturing, 2019
- Numerical simulation of WAAM process by a GMAW weld pool modelWelding in the World, 2018
- Open-source wire and arc additive manufacturing system: formability, microstructures, and mechanical propertiesThe International Journal of Advanced Manufacturing Technology, 2017
- Understanding of the weld pool convection in twin-wire GMAW processThe International Journal of Advanced Manufacturing Technology, 2016
- The effect of oxygen on transitional Marangoni flow in laser spot weldingActa Materialia, 2010
- The modelling of heat, mass and solute transport in solidification systemsInternational Journal of Heat and Mass Transfer, 1989