Wear Resistance and Titanium Adhesion of Cathodic Arc Deposited Multi-Component Coatings for Carbide End Mills at the Trochoidal Milling of Titanium Alloy
Open Access
- 30 June 2020
- journal article
- research article
- Published by MDPI AG in Technologies
- Vol. 8 (3) , 38
Abstract
The work was devoted to the study of the effectiveness of the application of multi-component coatings, TiN–Al/TiN, TiN–AlTiN/SiN, and CrTiN–AlTiN–AlTiCrN/SiN, obtained by cathodic arc deposition to increase the wear resistance of 6WH10F carbide end mills in trochoidal milling of titanium alloy. The surface morphology of the tool with coatings was studied using scanning electron microscopy, and surface roughness texture was estimated. Microhardness and elastic modulus of the coated carbide tool surface layer were determined by nanoindentation. The process of sticking titanium to the working surface of the tool and quantitative evaluation of end mill wear with multi-component coatings at the trochoidal strategy of milling titanium alloy was studied. The CrTiN–AlTiN–AlTiCrN/SiN coating showed the maximum value of the plasticity index at the level of 0.12. The maximum effect of reducing the wear rate was achieved when using a tool with a CrTiN –AlTiN–AlTiCrN/SiN coating when the operating time to failure of end mills was increased by 4.6 times compared to samples without coating, by 1.4 times compared with TiN–Al/TiN coating and 1.15 times compared with TiN–AlTiN/SiN coating.Keywords
Funding Information
- Ministry of Science and Higher Education of the Russian Federation (0707-2020-0025)
This publication has 74 references indexed in Scilit:
- Influence of deposition parameters of the Ti-Al-N/Zr-Nb-N-Cr-N multilayered nanostructured coating obtained by the arc-PVD method on their physicomechanical, tribological, and operational propertiesRussian Journal of Non-Ferrous Metals, 2012
- Broad beam sources of fast molecules with segmented cold cathodes and emissive gridsInstruments and Experimental Techniques, 2012
- Cutting Tools Nitriding in Plasma Produced by a Fast Neutral Molecule BeamJapanese Journal of Applied Physics, 2011
- Glow discharge with electrostatic confinement of electrons in a chamber bombarded by fast electronsPlasma Physics Reports, 2011
- An experimental and numerical study on the face milling of Ti–6Al–4V alloy: Tool performance and surface integrityJournal of Materials Processing Technology, 2011
- A compact vapor source of conductive target material sputtered by 3-keV ions at 0.05-Pa pressureInstruments and Experimental Techniques, 2009
- Broad beam source of fast atoms produced as a result of charge exchange collisions of ions accelerated between two plasmasInstruments and Experimental Techniques, 2009
- Trochoidal millingInternational Journal of Machine Tools and Manufacture, 2007
- Broad fast neutral molecule beam sources for industrial-scale beam-assisted depositionSurface and Coatings Technology, 2002
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992