Analysis of Tool Oscillation and Hole Roundness Error in a Quasi-Static Model of Reaming
Authors:
- 1 November 2000
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 123 (3) , 387-396
Abstract
A quasi-static model of reaming is developed to explain oscillation of the tool during cutting and the resulting roundness errors in reamed holes. A tool with N evenly-spaced teeth often produces holes with N+1 or N−1 “lobes.” These profiles correspond, respectively, to forward or backward whirl of the tool at N cycles/rev. Other whirl harmonics (2N cycles/rev, e.g.) are occasionally seen as well. The quasi-static model is motivated by the observations that relatively large oscillations occur at frequencies well below the natural frequency of the tool, and that in this regime the wavelength of the hole profile is largely independent of both cutting speed and tool natural frequency. In the quasi-static approach, inertial and viscous damping forces are neglected, but the system remains dynamic because regenerative (time-delayed) cutting and rubbing forces are included. The model leads to an eigenvalue problem with forward and backward whirl solutions that closely resemble the tool behavior seen in practice.Keywords
This publication has 14 references indexed in Scilit:
- Perturbation Methods in Nonlinear Dynamics—Applications to Machining DynamicsJournal of Manufacturing Science and Engineering, 1997
- Analytical Prediction of Stability Lobes in MillingCIRP Annals, 1995
- Modeling transverse motions of a drill bit for process understandingPrecision Engineering, 1993
- A New Theoretical Approach for the Prediction of Machine Tool Chatter in MillingJournal of Engineering for Industry, 1993
- Dynamic Modeling and Analysis of the Boring Machining SystemJournal of Engineering for Industry, 1987
- Modeling and Analysis of the Dynamics of a Drill Penetrating a Thin PlateJournal of Applied Mechanics, 1986
- Whirling Vibration in Drilling. Part 2: Influence of Drill Geometries, Particularly of the Drill Flank, on the Initiation of VibrationJournal of Engineering for Industry, 1986
- Whirling Vibration in Drilling. Part 1: Cause of Vibration and Role of Chisel EdgeJournal of Engineering for Industry, 1986
- Comparison of properties of joints prepared by ultrasonic welding and other meansJournal of Aircraft, 1983
- Quantification of Fastener- Hole QualityJournal of Aircraft, 1978