Comparison of Brazed Residual Stress and Thermal Deformation between X-Type and Pyramidal Lattice Truss Sandwich Structure: Neutron Diffraction Measurement and Simulation Study
Open Access
- 23 July 2015
- journal article
- research article
- Published by Walter de Gruyter GmbH in High Temperature Materials and Processes
- Vol. 35 (6) , 567-574
Abstract
This paper uses finite element method and neutron diffraction measurement to study the residual stress in lattice truss sandwich structure. A comparison of residual stress and thermal deformation between X-type and pyramidal lattice truss sandwich structure has been carried out. The residual stresses are concentrated in the middle joint and then decreases gradually to both the ends. The residual stresses in the X-type lattice truss sandwich structure are smaller than those in pyramidal structure. The maximum longitudinal and transverse stresses of pyramidal structure are 220 and 202 MPa, respectively, but they decrease to 190 and 145 MPa for X-type lattice truss sandwich structure, respectively. The thermal deformation for lattice truss sandwich panel structure is of wave shape. The X-type has a better resistance to thermal deformation than pyramidal lattice truss sandwich structure. The maximum wave deformation of pyramidal structure (0.02 mm) is about twice as that of X-type (0.01 mm) at the same brazing condition.Keywords
This publication has 31 references indexed in Scilit:
- Multiaxial creep of low density open-cell foamsMaterials Science and Engineering: A, 2012
- Modeling and microstructural analysis of temperature effects in fused silica viewportFusion Engineering and Design, 2011
- Critical comparison of two independent measurements of residual stress in an electron-beam welded uranium cylinder: Neutron diffraction and the contour methodActa Materialia, 2011
- Microstructure changes during non-conventional heat treatment of thin Ni–Ti wires by pulsed electric current studied by transmission electron microscopyActa Materialia, 2010
- Residual stress brazing process induced in hybrid package for ISP applicationsActa Astronautica, 2010
- Mechanical properties of an extruded pyramidal lattice truss sandwich structureScripta Materialia, 2008
- Finite element modeling of creep deformation in cellular metalsActa Materialia, 2007
- Shear fatigue strength of a prismatic diamond sandwich coreScripta Materialia, 2007
- Predicting the effect of residual stress on fatigue crack growthInternational Journal of Fatigue, 2007
- Contribution of vortex structures and flow separation to local and overall pressure and heat transfer characteristics in an ultralightweight lattice materialInternational Journal of Heat and Mass Transfer, 2005