Precipitation during Quenching in 2A97 Aluminum Alloy and the Influences from Grain Structure
Open Access
Abstract
The quench-induced precipitation and subsequent aging response in 2A97 aluminum alloy was investigated based on the systematic microstructure characterization. Specifically, the influence on precipitation from grain structure was examined. The results indicated the evident influence from the cooling rate of the quenching process. Precipitation of T1 and δ′ phase can hardly occur in the specimen exposed to water quenching while become noticeable in the case of air cooling. The yield strength of 2A97-T6 alloy de-graded by 234 MPa along with a comparable elongation when water quenching was replaced by air cooling. Sub-grains exhibited a much higher sensitivity to the precipitation during quenching. The presence of dislocations in sub-grains promoted the quench-induced precipitation by acting as nucleation sites and enhancing the diffusion of the solute. A quenching rate of 3 °C/s is tolerable for recrystallized grains in 2A97 Al alloy but is inadequate for sub-grains to inhibit precipitation. The study fosters the feasibility of alleviating quench-induced precipitation through cultivating the recrystallization structure in highly alloyed Al–Cu–Li alloys.Keywords
Funding Information
- National Natural Science Foundation of China (51971077, U1737206)
This publication has 50 references indexed in Scilit:
- Quantitative analysis of the influences of pre-treatments on the microstructure evolution and mechanical properties during artificial ageing of an Al–Cu–Li–Mg–Ag alloyMaterials Science and Engineering: A, 2020
- Review of the Quench Sensitivity of Aluminium Alloys: Analysis of the Kinetics and Nature of Quench-Induced PrecipitationMaterials, 2019
- Influence of Mg content on ageing precipitation behavior of Al-Cu-Li-x alloysMaterials Science and Engineering: A, 2019
- The effect of minor solute additions on the precipitation path of an Al Cu Li alloyActa Materialia, 2016
- Influence of grain structure and crystallographic orientation on fatigue crack propagation behavior of 7050 alloy thick plateInternational Journal of Fatigue, 2014
- Residual stress reduction in 7175-T73, 6061-T6 and 2017A-T4 aluminium alloys using quench factor analysisJournal of Materials Processing Technology, 2004
- A quench sensitivity study on the novel Al–Li–Cu–X alloy AF/C 458Journal of Light Metals, 2002
- Quench sensitivity and tensile property inhomogeneity in 7010 forgingsJournal of Materials Processing Technology, 2001
- Numerical calculations of residual–stress relaxation in quenched platesMaterials Science and Technology, 1985
- Finite element calculation and measurement of thermal stresses in quenched plates of high–strength 7075 aluminium alloyMaterials Science and Technology, 1985