Knudsen pump based on silicon etching and thermal oxidation process for on-chip vacuum pumping
- 1 December 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 550-552
Abstract
This work reports the fabrication and evaluation of Knudsen pump for on-chip vacuum pumping. Three AFM (atomic force microscope) cantilevers are integrated into small chambers with a size of 5 mm × 3 mm × 0.4 mm for the pump's evaluation. Knudsen pump is fabricated using deep RIE (reactive ion etching), wet thermal oxidation and anodic bonding processes. The fabricated device is evaluated, which based on monitoring the quality (Q) factor of the integrated cantilevers. The Q factor of the cantilever is increased from 300 to 1150 in cases without and with a temperature difference approximately 25°C between the top (hot side at 40°C) and bottom (cool side at 15°C) sides of the fabricated device, respectively. The evacuated pressure chamber of around 10 kPa is estimated by the Q factor of the integrated cantilevers.Keywords
This publication has 7 references indexed in Scilit:
- On the Small-Signal Capacitance of RF MEMS Switches at Very Low FrequenciesIEEE Journal of the Electron Devices Society, 2016
- A Monolithic High-Flow Knudsen Pump Using Vertical Al2O3 Channels in SOIJournal of Microelectromechanical Systems, 2015
- An Integrated Electrostatic Peristaltic 18-Stage Gas Micropump With Active MicrovalvesJournal of Microelectromechanical Systems, 2014
- Fabrication of an hermetically packaged silicon resonator on LTCC substrateMicrosystem Technologies, 2012
- A review of MEMS oscillators for frequency reference and timing applicationsJournal of Micromechanics and Microengineering, 2011
- A vacuum packaged surface micromachined resonant accelerometerJournal of Microelectromechanical Systems, 2002
- A valveless diffuser/nozzle-based fluid pumpSensors and Actuators A: Physical, 1993