An Experimental Study into the Behaviour of Tube and Fitting Scaffold Structures under Cyclic Side and Vertical Loads
Open Access
Abstract
The United Kingdom and European codes for the analysis and design of tubular scaffold structures assume that the scaffolds are subjected primarily to vertical loads and to horizontal loads at right-angles to the scaffold. The effects of dynamic loading caused by large winds tend to be ignored and the code analyses often only require static loading on the structures to be considered. To investigate side loads, a scaffold frame built according to the UK standard was made and inserted into a testing rig. Five different load combinations were made to determine the behaviour of the scaffold under different side loads, which were varied cyclically to simulate different wind loads, especially when vertical loads were also applied. The results showed that cyclical loads affected scaffold behaviour, especially when the bases of the scaffold standards were not tied to the base at the bottom of the test rig. Changes should be made to the UK and European codes BS EN 74.1, BS 5975 and BS EN 128 11-1 for the design of scaffold structures to increase safety.Keywords
This publication has 11 references indexed in Scilit:
- Properties of tube and fitting scaffold connections under cyclical loadsJournal of Constructional Steel Research, 2020
- Design Solutions and Innovations in Temporary Structures2017
- Scaffold research — A reviewJournal of Constructional Steel Research, 2014
- Cyclic stress-strain behavior of structural steel with yieldstrength up to 460 N/mm2Frontiers of Structural and Civil Engineering, 2014
- Effect of Loading Protocols on the Hysteresis Behaviour of Hot-Rolled Structural Steel with Yield Strength up to 420 MPaAdvances in Structural Engineering, 2013
- Structural modelling of support scaffold systemsJournal of Constructional Steel Research, 2011
- Investigation of geometric imperfections and joint stiffness of support scaffold systemsJournal of Constructional Steel Research, 2011
- Rotational strength and stiffness of tubular scaffold connectorsProceedings of the Institution of Civil Engineers - Structures and Buildings, 2009
- THE COLLAPSE STRENGTH OF TUBULAR STEEL SCAFFOLD ASSEMBLIES.Proceedings of the Institution of Civil Engineers, 1977
- The idealization of scaffold couplers for performance tests and scaffold analysisMaterials and Structures, 1977