Fabrication of TiC–Fe cermet coating by plasma spraying of Fe–Ti–C powder using sucrose as carbon source
- 1 May 2010
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 26 (5) , 579-585
Abstract
A mixture of ferrotitanium and sucrose was heated to carbonise the sucrose, so the ferrotitanium particles were bound by the carbon obtained from the pyrolysis of sucrose. Then a Fe–Ti–C composite powder was made for reactive thermal spraying, which could avoid separation of Ti and C during spraying. The carbon is a reactive constituent as well as the binder in the composite powder. While this powder was used to deposit cermet coating by plasma spraying, a mass of TiC particles were in situ synthesised and uniformly distributed within metallic matrix. Average microhardness and surface hardness of the TiC–Fe coating are about 1672·5 HV0·2 and 91·4 HR(15 N) respectively. Adhesive strength value of the coating reaches 61·86 MPa. Finally, the cermet coating has good wear resistance performance.Keywords
This publication has 24 references indexed in Scilit:
- Microstructure and properties of TiC–Fe cermet coatings by reactive flame spraying using asphalt as carbonaceous precursorCeramics International, 2007
- Microstructural characterization and wear behavior of (Fe,Ni)–TiC MMC prepared by DMLSJournal of Alloys and Compounds, 2006
- Uniform carbon-covered titania and its photocatalytic propertyJournal of Molecular Catalysis A: Chemical, 2005
- Interfacial phenomena in wettability of TiC by Al–Mg alloysActa Materialia, 2004
- Production of nanocrystalline cermet thermal spray powders for wear resistant coatings by high-energy millingMaterials Science and Engineering: A, 2003
- Effect of matrix composition on the microstructure of in situ synthesized TiC particulate reinforced iron-based compositesMaterials Letters, 2003
- Low temperature mechanism for the formation of polycyclic aromatic hydrocarbons from the pyrolysis of celluloseJournal of Analytical and Applied Pyrolysis, 2003
- Effect of substrate roughness induced by grit blasting upon adhesion of WC-17% Co thermal sprayed coatingsThin Solid Films, 2000
- SHS powders for thermal spray applicationsCeramics International, 1997
- Oxidation behavior of WC-CoMaterials Science and Engineering: A, 1996